Selling Leads -- Sell High-definition Waterproof CMOS Camera ...

Description:
MODEL CA-205


SPECIFICATION

Image Device �� CMOS
TV System �� PAL , NTSC
Effective Pixels �� 512*492
Sensing Area �� 4.69*3.54mm
Scanning System �� 2:1 Interlace
Sync.System �� Internal
Resolution �� 380TV Lines
Horizontal Sync Frequency �� 15.625 KHz (PAL), 15.734 KHz(NTSC)
Vertical Sync Frequency �� 50 Hz (PAL), 60 Hz (NTSC)
Minimum Illumination �� 2.0 Lux F1.2 (NO Infrared) (PAL), 0 Lux F1.2(Infrared) (NTSC)
Video Output �� 1.0Vp-p,75hm
AGC �� AUTO
S/N Ratio �� ≧48dB
White Balance �� AUTO
Electronic Shutter �� 1/50 or 1/15000s (PAL), 1/60 or 1/15000s (NTSC)
BLC �� ON
Current Consumption �� 50mA
Power Supply �� DC12V
Operating Temperature �� -20�ɢ�+50��
Lens �� 2.5mm
Lens Angle �� 120��


Installation:

1. Looking for a suitable position on the trunk lid/ licence plate /rear bumper to install the camera.
2. Extend camera cable (signal cable and power wire) through the licence plate / rear bumper , along with the trunk lid and fix the cable line and the camera.
3. Find the power wire (anode & cathode wire) of reverse light. And connect the power wire from the camera to the anode wire of the reverse light.
4. Connect the yellow connector of the camera to the other yellow connector. Connect the black connector of the camera to the black connector which is electrified and set the cable line on a suitable position.
5. Extend the signal cable through the side of back chair, along with the interspaces of the car doors to the display.
6. Connect the signal connector to the display.
7. Turn on the power for testing the image.