1-4 Channels BNC To UTP Video Transceiver

Description:
The passive (no-amplified) device that allows the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire. Baseband (Composite) signals of any type aresupported.



Up-the-coax type P / T / Z signals can be sent over the same wire. Used as a receiver, the 4channel Video Transceiver is fully compatible with other balance signal output.



The unparalleled interference rejection and low emissions of the 4channel Video Transceivers allow video signals to co-exist in the same wire bundle as telephone, datecom, or low-voltage power circuits. This allows the use of shared or existing cable plant. With built-in transient protection, damaging voltage spike problems are eliminated



Feature



Four passive transceiver channels in one product.



Full-motion CCTV video at distances up to 750ft (225m) when used with passive transceiver.



Up to 3000ft (1km) with an active receiver.



No power required.



Exception interference rejection.



Built-in polarity protection.



Technical Specifications



Video



Frequency Response DC to 5 MHz



Attenuation 0. 5db type



Common-mode / Differential-mode Rejection



15KHz to 5 MHz 60 dB type



Impedance



Coax, female BNC 75 ohms



UTP, Terminal Block 100 ohms