Factory Supplier EPDM Rubber Cold Shrink Tube

HarshMet Durable LV Cable Splice Kit EPDM Rubber Cold Shrink Tube CPE Series
For Electrical, Telecom and Industrial Applications
 

 

HarshMet EPDM Cold Shrink Tubes are a series of open-ended, tubular rubber sleeves, which are factory expanded and assembled onto a removable core. They are supplied for field installation in this pre-stretched condition. The core is removed after the tube has been positioned for installation over an in line connection, terminal lug, etc., allowing the tube to shrink and form a waterproof seal. The insulating tube is made of EPDM rubber, which contains no chlorides or sulphurs.A wide range of diameter sizes and lengths will cover a range of 1000 volt cables, copper and aluminium conductors.
 

 

Simple installation, requires only workman's hands 
Accommodates a wide range of cable sizes 
No torches or heat required 
Good thermal stability 
Seals tight, retains its resiliency and pressure even after prolonged years of ageing and exposure 
Excellent wet electrical properties 
Improved tough rubber formulation to with stand rough backfilling 
Resists fungus v Resists acids and alkalis 
Resists ozone and ultraviolet light
 

 

Primary electrical insulation for all solid dielectric (rubber and plastic) insulated wire and cable splices rated to 1000 volts 
Directly buriable or submersible 
For indoor, outdoor, or overhead use 
Physical protection and moisture sealing for high-voltage, air-insulated connectors and lugs such as spacer cable and lug connections to bus bar 
Insulation of secondary splices copper or aluminium conductors 
Relocation of service v Dig-in repairs 
Sheath repairs 
Insulation of inline conductor transition connectors
Sealing of jumper-to-feeder and jumper-to-equipment RF coax connections