Galvanized Double Keel Clamp Tool

Used to put together wooden boards. The general structure is two parallel rods above and below, and two clamps on the side. When locking, not only do the clamps on both sides clamp towards the middle, but they also clamp up and down twice to ensure that the board is flat. This may be more practical for professional studios, but it is not recommended for people who occasionally put together boards. You can achieve the same effect by clamping two flat pieces of wood up and down.The structure is very simple, two pieces of wood plus two screws. The angle and width of the clamp can be controlled. There are many other ways to use it, such as clamping this wooden clamp to the leg clamp of the woodworking table and then clamping the workpiece to increase the height or fix the workpiece at an angle. Or use it to fix multi-layer boards vertically.