High Anti-Corrosion Thermoplastic Powder Coating for Battery Box

High Anti-corrosion Thermoplastic Powder Coating for Battery Box





Polyethylene Powder Coating
Polyethylene Powder Coating is a thermoplastic powder coating modifed with low density polyethylene (LDPE) resin as based materiaormulated with various functiona additives to provide excel ent performance. It has excelent adhesion, ant-corrosion properties, good chemicastabity, electrical insulation and low temperature resistance of polyethylene itself. Typically, they are widely used to coat household and industriametal wire products.This is because they provide a smooth and attractive surface coating that is hard enough to withstand severe wear and tear





Strong Adhesion
We al know that in order to improve adhesion, it is generally necessary to apply a primer between the parts and the powdercoating.But our polyethylene powders are extremely viscous, it breaks this limitation. So no primer needed anymore! in addition, itoffers excellent edge protection and excellent coverage; therefore, it can withstand severe impacts without being peeled off easily.



Good Mechanical Properties
it has excelent impact and abrasion resistance, which means our polyethylene powder coatings are durable enough to withstandyears of harsh environments and use. At the same time, it has good corrosion resistance, water resistance and electrical insulation.



High Adaptable
It is suitable for a variety of applications, whether for indoor or outdoor use. At the same time, they also have excellent pertormanceat lower temperatures without compromising thermal stability and stress crack resistance.



Fluidized Bed Dip

The preheated workpiece is completely immersed into fluidized bed. The powder melts on contact with the workoiece and the workoiece is thenifted out of the fluidized bed. The workpiece is then cooled to leave a high-quality coatinq.Pre-treatment: Oil and rust removed by chemical method or sandblasting.2.Workpiece Preheat: 250-320C[ adjusted according to the workpiece].3.Fluidized Bed Dip: 4-8 seconds [adjusted according to the workpiece].4. Post-heatoptional): 180-250C, 5 minutes  Beneficial to obtain a better surface ]5.Cooling:Air-cooled or naturally cooled.