Hot Isostatic Press Machine, Hydraulic Press, CIP Machinery Equipment

1. Maximum working pressure: 200MPa;
2. Maximum working temperature: 2000ºC,Common operating temperature:1850ºC;
3. The effective diameter of heat zone:Φ500mm;
4. The effective height of heat zone:1500mm;
5. Heating material:C/C;
6. Temperature thermocouple:WRe3/25(JB/T9497-2002),when working temperature is not less than1700ºC,the Thermocouple service life is 1 furnace time;
7. Working medium:high purity nitrogen or argon(99.99%);
8. Vacuum degree(room temperature,no working parts):≤500Pa; 
9. Vacuum time(room temperature,no working parts):t≤30min;
10. Maximum temperature deviation of effective hot zone from 800ºC to 1850ºC(no working parts,Heat preservation stage,pressure 50MPa~150MPa,Refer to GB/T9452-2012 and adopt the WRE3/25 workpiece thermocouple for 9 point temperature measurement):≤±10ºC;
11. Heating up time(no working parts):room temperature~1850ºC≤4h;
12. 0~60MPa Prepressurized time(no working part):≤4h;
13. Maximum weight capacity of working table:600kg;
14. Gas recovery rate:≥80%;
15.  Pressure measurement accuracy:≤0.5%F.S.;
16. Loading mode: upper loading;
17. Install way: Pit installation, ground operation

 

 

1. Altitude:≤2000m;
2. Temperature:+5ºC~+40ºC;
3. Relative humidity of air is not more than 90%(20ºC);
4. Power supply requirement:Installation power is about 1200kW(AC380V±10%,50Hz±1%,TN-S income wire system);
5. Water supply requirement:Pressure0.3~0.5MPa, Flow≥50m³/h,Water inlet temperature ≤30ºC,Water outlet temperature≤45ºC;
6. The working limit height of the crane hook in the workshop of the hot isostatic press is  from the ground≥5.5m,hoisting weight≥6t;
7. A place free from fire,serious pollution,chemical corrosion,violent vibration and strong disturbance sources.

Our main type of press  is as follows:


1. Cold Isostatic Press:a. The vessel inner materials is 34CrNi3MoV alloy whole parts forged and then The forged vessel be wire wounded by alloy of wire(65Mn steel 1.5mm x 6mm size) as per the designed.
b.Whole procedure of the cold isostatic pressing (CIP) machine, increasing, holding and releasing pressure is controlled by PLC and also there is a decompression system to protect the system over pressure to keep the machine in safety running

2. Hot Isostatic Press:
3.  Warm Isostatic Press:a.The vessel inner materials of WIP is 34CrNi3MoV alloy whole parts forged and then The forged vessel be wire wounded by alloy of wire(65Mn steel 1.5mm x 6mm size) as per the designed.
b.Whole procedure of the warm isostatic press machine (WIP ) , increasing, holding and releasing pressure is controlled by PLC and also there is a decompression system to protect the system over pressure to keep the machine in safety running.

Contact Us: