Imtp Random Packing

Metal Intalox saddle ring:
As one of the third generation of excellent metal random packing,Metal Intalox saddle ring is designed by combining the characteristics of both the ring and the saddle. This structure not only facilitates gas-liquid passage ,but also reduces the dead zone of stagnant liquid in the packing layer. Compared with peers, 22 fully automatic stamping production lines and Independently developed integrated stamping die 100% guarantees the high quality and high output of the product.

30% Lower pressure dorp than Pall ring's
Geometric design minimized liquid hold-up
Greater Capacity & efficiency than other random packings
 

General Information There are many ways to install random packing. Installation procedures vary depending on the column diameter, size of packing, packed bed height, and position of other internals. For small diameter columns of less than 30 inches, it is usually easier to load through lower level manways or use a chute to lower the packing to the support level. For larger columns, it may be possible to place men inside so that complete boxes or bags can be lowered and manually dumped. Extreme caution should be used in this procedure to make sure that the packing support is designed to hold the combined load of the workman and the packing. Another method is to attach a rope on the top of a bucket and another on the bottom and lower the packing to the desired level. The rope attached to the bottom would then be used to tip the bucket over. Finish all welding or other work that produces hot sparks before installing any packing. Test the dimensional compatibility of the individual packing pieces with the openings in the support grid. Make sure that it is not possible for packing to squeeze through any openings.

Acid gas removal
Demethanizer / deethanizer
Ethylene water quench and primary fractionator
Sour water stripper
Atmospheric and high pressure distillation