Menu
Suppliers Products
Global B2B sourcing platform
Verified suppliers and manufacturers
MadeInChina.com > Products > Electrical & Electronics > Transmitter > Other Transmitters
Swipe or use the arrows to view product images.

Magnetic Tape for Magnetic Guide Sensor of Agv

Price $1.20
Min Order 1 Meter
Availability In Stock
Shipping From Shanghai, China
Popularity 335 people viewed
Send Inquiry View Full Page
Model NO.:
MGT-50-25
Function:
Over Voltage Protection, Short Circuit Protection
Materials:
Magnesium Alloy
Type:
Agv
Cooling System:
Air
Trademark:
yuanben
Transport Package:
Standard Export Package
Specification:
CE
Origin:
Shanghai
HS Code:
9033000000
Product Description
Magnetic Tape for AGV Magnetic Guide Sensor
MGT series magnetic guide tape is used for magetic guide sensors.

Features
  1. Magnet: Anisotropic strontium ferrite (Binder; Chlorinated polyethylene polymer alloy)
  2. Residual magnetic flux density; Br 220~245mT (2200~2450G)  
  3. Coercivity; bHc 159~183kA/m (2000~2300Oe)
  4. iHc207~262kA/m (2600~3300Oe)
  5. Maximum energy product; B·H (max)9.03~10.8kJ/m3 (1.13~1.35MGOe)
  6. Operation temperature:-20~+60ºC
  7. Storage temperature:-30~+70ºC
Dimension

MGT-50-25 50mm wide, 2mm thick, 25m long, magnet only or with self-adhesive tape

 Installation
  1. Remove dust, water or oil from floor surface.
  2. Peel off the release liner and stick it on the floor along AGV route.
Notices
  1. Magnetic guide tape can be attached on ferrous material floor but should not be embedded in ferrous material floor, since the magnetic flux from the guide tape is greatly reduced.
  2. Magnets at vicinity of magnetic Guide ape may cause turbulence of magnetic flux distribution . proximity of strong magnet ( approx 1 KGs and more ) to magnetic guide tape may change the magneic flux distribution of guide tape.
  3. Normal running routes should keep distance more than 500 each other.
  4. Adhesion of ferrous powder iron etc. on magnetic guide tape may cause reduction of magnetic flux density. Remove the adhesive ferrous powder from guige tape regularly.
  5. Each end of magnetic guide tape should be connected within 2 mm slit.
  6. Keep chemicals and solvent (acetone, thinner, etc.) away, since it may change the shape and characteristics of magnetic guide tape.  
  7. Nonferrous material (aluminum, SUS-304, etc.) can cover magnetic guide tape for protection. But ferrous material (iron, SUS-303, etc.) should not cover magnetic guide tape since magnetic flux from magnetic guide tape is shielded at the area where is covered by ferrous material.
* Specifications are subject to change without notice. *

Photos


 



  • Similar Products
Full Page Contact Supplier
↑