PVC Floor Production Line Loading and Unloading System

Auto Loading and unloading system

Trimming machine is used to cut the floor to meet the size requirements of the finished board.  in order to ensure that the size of the floor meets the specified requirements, there is usually a margin size left. Therefore, the floor after hot press is slightly larger than the specified size. Through the process of trimming, the margin-left will be removed.

Loading and unloading for thermo press machine
Rack Material:carbon steel
Host Dimension:2600×2000×2500mm
Machine equipped Total Power:8.4KW
Power Supply:three-phase AC380V

*Flexible and is suitable to any work place.
*Suitable for DIY works allowing high reliability of the equipment at a low cost, compact, lightweight, high quality.
*Full set of accessories ,enable easier operation 
 
double loading and unloading system
single loading and unloading system
Hoist assembly stage is to operate through five flakes care delivered to presses roll.Up and down movement by the two hydraulic cylinders lift.About motorized roller conveyor are sent from the front and back action from the bottom four wheels through a geared motor forward and back on the track,but also install console,the operator with the surface warfare in the above operation,is very convenient,is the ideal device of choice.


CONTACT US