Rubber Conveyor Belt Repairing Press Rail-Mounted Spot Repair Vulcanizer

The proper model selection for a sectional vulcanizier depends on determining dimensions A and B(see diagram above)

A-  the platen length(A) is calculated by adding to the belt manufacturer's recommended splice length.

 6 inches(150mm) for fabrics belt

14 inches(355mm) for steelcord belt

B- the platen width(B) which includes the bias angle, it determined by adding to the belt width

6 inches(150mm) for fabric belt

8 inched(200mm) for steelcord belt

To this figure multiply by:

1.07 for 22 degree bias angle

1.05 for 17 degree bias angle

Dimensions A and B represent the outside platen dimensions. Scan down the list below until  you arrive at a platen size the corresponds with your figures.

If the size you require is not listed below our Sales department will be happy to recommend a suitable size, rectangular configurations and multiple platen arrangements are also available upon request.
 

Specifications are subject to change without notice.

Build-in cooling device on all vulcanizer.

Total weights include electrical control panel, cable sets are set-up templates for all models.

All models include electronic fluid pressure pump

Temperature adjustable between 0-199 Degree.C

Sectional vulcanizers are build on a 18 degree bias

Custom sizes, rectangular configurations and multiple  platen arrangements available on request.