Strong 10ml Primer Adhesive Adhesion Promoter Super Bonder Strong Acrylic Foam Double Sided Tape Primer for Car Accessories

The main purpose of the primer is to strengthen the adhesive effect of films, tape or other self-adhesive materials.

Why use primer?

- Prime ensures better adhesion of paint to the surface, increase durability, and provides additional protection for the material being painted.

- It allows things to adhere much better than using any other adhesive materials alone.

-The main purpose of the primer is to strengthen the adhesive effect of films, tape or other self-adhesive materials. Primer - -an indispensable assistant at the car wrapping vinyl film! Without it, no professional work done.

Features:

Tape Primer can ONLY be used to promote adhesion of tapes to surfaces such as polyethylene, polypropylene, ABS, PET/PBT blends, concrete, wood, glass, metal and painted metal surfaces.

Tips for using:

- Surface Preparation: The bonding surface must be relatively clean and dry. Contaminated surfaces should be cleaned with a 50/50 I sopropyl Alc ohol and water mixture.

- Make sure the primed surface remains free from contaminants before you apply the tape.

- THIS IS NOT A GLUE AND CANNOT BE USED SOLELY AS A GLUE. THE ADHESION PROMOTER IS FOR BETTER ADHESION OF YOUR TAPE. YOU NEED TO APPLY IT ON A TAPE OR ANYTHING ADHESIVE.

This is an adhesion promoter, not a glue (Need to be used together with double-sided tape for better use)

Tapes+ primer Time:After application, the bond strength will increase as the adhesive flows onto the surface. At room temperature approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hoursand 100% after 72 hours.

Primer application:

1. Apply the primer to a clean, dry surface (simply ''paint'' the spot)

2. Shake primer well before using.

3. Leave the primer for a few minutes before applying tape. This is usually accomplished in 5 minutes at room temperature.

4. Primer may be applied with brush or swab. It can also be applied with a pressurized flow gun, knurled roller or other similar type of application equipment.

5. Allow 72 hours of dwell time before us(80% Increase Viscosity)