Wet Waxing Agent for Yarn (Cotton) Db-61

Special Properties

1. Mainly apply for waxing treatment of exhaustion dyeing on cotton yarns, dynamic friction value on the surface of fabrics after being treated is low and a better woven property can be gained.

2. Has an affinity to fibers that way that it can be used for yarns having been submitted to cationic after-treatment. Even in these cases a water clear exhaustion can be achieved

3. Provide yarns with optimal gliding properties which is achieved by carefully selected waxes. Yarns treated has a low friction coefficient.

Chemical Composition: Compositions of fatty acid derivatives
Miscibility: Can be bathed with non-ionic or cationic auxiliaries

pH(100%): 3~5

Storage: Can be stored for 6 months in closed container and under normal temperature after EX factory, and no storage under freezing ambient condition

Application and Process

Process Parameters:

DB-61   1.0~ 3.0% (o.w.f)

Acetic Acid (98%): 0.2 ~0.4ml/l (adjust pH value between 5.0~5.8)

Process Conditions: running 5 min under ambient temperature after adding waxing agent, raising to 50ºC~60ºC slowly, thermal preserved for 15~20 min.  Recycling mode is going to be 1:2(Inside ~outside, outside ~ inside)

Drying: at normal or elevated pressure, temperature could be up to 130ºC.

Notes:

(1).Diluted with cold water first, stirring uniformly and then adding into bath lotion

(2).Being treatment, the hand feeling of this product will be not as soft as traditional technology, but with superior weaving performance, normally no need to adding softener, if any requirement of softness, sheet film may be added to improving the hand feeling.