Audited Supplier
EG-Nylon
PA6
Sheet
＜0.4%
20mm-500mm
1100mm X 2200mm 1000mm X 2000mm
Energetic
Customized
RoHS
China
3920920000
Product Description
Engineering MC Nylon Plastic Sheet , Cast Nylon Sheet with RoHS
About Nylon:
The most common engineering nylons are PA6 and PA66. Nylon stock shapes are produced by either extrusion or casting. The process is in part a determinant of the nylon properties of the end product. Modifiers are added to enhance desirable characteristics.
Advantages:
Nylon Rod and Nylon Sheet are tough, durable, general purpose engineering material with special grades for specialty applications. Typical application conditions would be medium speed and temperature in a rugged, abrasive, impact and high load environment.
Disadvantages:
Poor dimension stability, electrical and mechanical properties, may become affected by absorbing moisture or water, acidproof ability not good, can't dye with acid or touch overmuch acid, weak lightfastness, low endurance in pollution
Key Features:
| Trade names: | Polyamides, PA, Nylon |
| Available Shapes: | Sheets, Rods, Tubes, Plates, Parts |
| Color: | Natural White, Black, Green, Others |
| Sheets Thickness: | 7mm ~ 200mm |
| Size: | 1100 x 2200mm |
| Rods Diameter: | 20mm ~ 400mm |
| Length: | 1000mm ~ 6000mm |
About Nylon:
The most common engineering nylons are PA6 and PA66. Nylon stock shapes are produced by either extrusion or casting. The process is in part a determinant of the nylon properties of the end product. Modifiers are added to enhance desirable characteristics.
Advantages:
Nylon Rod and Nylon Sheet are tough, durable, general purpose engineering material with special grades for specialty applications. Typical application conditions would be medium speed and temperature in a rugged, abrasive, impact and high load environment.
Disadvantages:
Poor dimension stability, electrical and mechanical properties, may become affected by absorbing moisture or water, acidproof ability not good, can't dye with acid or touch overmuch acid, weak lightfastness, low endurance in pollution
Key Features:
- Excellent bearing properties
- High impact strength and toughness
- Low power factor requirements
- High wear resistance
- Very good sliding properties
- High load bearings
- Wear pads
- Support and Guide wheels
- Conveyor and Tension rollers
- Wire rope sheaves
- Buffer pads
- Gears...
- Extruded Nylon 6 (PA 6) - natural (white) / black:
- MC Nylon 6 (PA 6) - natural (ivory) / black:
- MC Nylon 6 + oil filled (PA6 + oil) - green:
- Nylon 6 + MOS2 (PA6 + MoS²) - grey black:
- Nylon 6+ GF30 (PA 6-GF30) - black:
- Nylon 66: this material with a higher mechanical strength, stiffness, heat and wear resistance than extruded nylon 6. It also has a better creep resistance but its impact strength and mechanical damping ability are reduced. Well suited for machining on automatic lathes.
