Audited Supplier
9460-8i 2G
Full-Duplex & Half-Duplex
Controllers
12GB/S
≦8
Broadcom
Carton Packing
Malaysia
Product Description
Applications
• High-port count SAS/SATA/NVMe
controllers for direct-attached high connectivity applications
• Tri-Mode connectivity enabling
maximum data center flexibility
• Flexible solutions for cloud
computing
• External storage requiring high connectivity SAS/SATA interface
for host or drive side connect
Key Features
• Tri-Mode storage interface ports
− SFF-8680 bay
− x1 SAS
− x1 SATA
− x2 SAS (multi-link)
− Two x1 SAS (dual port using
MPIO)
− SFF-8639 (U.2) bay
− x2, x4 NVMe
• Supports 12, 6, and 3 Gb/s SAS and
6 and 3 Gb/s SATA data transfer
rates
• High-port count SAS/SATA/NVMe
controllers for direct-attached high connectivity applications
• Tri-Mode connectivity enabling
maximum data center flexibility
• Flexible solutions for cloud
computing
• External storage requiring high connectivity SAS/SATA interface
for host or drive side connect
Key Features
• Tri-Mode storage interface ports
− SFF-8680 bay
− x1 SAS
− x1 SATA
− x2 SAS (multi-link)
− Two x1 SAS (dual port using
MPIO)
− SFF-8639 (U.2) bay
− x2, x4 NVMe
• Supports 12, 6, and 3 Gb/s SAS and
6 and 3 Gb/s SATA data transfer
rates
| Product Name | Controllers |
| Warranty | 1 Years |
| Storage Temp / Humidity | -40 to 85ºC |
| Products Status | Brand-new |
| Output | 12-36V |
| 1. Unpack the HBA, and inspect it for damage. | Remove the HBA from the antistatic bag, and carefully inspect the device for damage. If you notice any damage, contact LSI or your reseller support representative. |
| 2. Prepare the computer. | Turn off the computer, and disconnect the power cord from the rear of the power supply. |
| 3. Remove the cover from the chassis. | |
| 4. Check the mounting bracket on the HBA (system-dependent). | If required for your system, replace the full-height mounting bracket that ships on the HBA with the low-profile bracket supplied. Complete step a through step d to attach the short bracket. |
| 5. Insert the HBA into an available PCIe® slot. | Locate an empty x8 PCIe slot. Remove the blank bracket panel on the rear of the computer that aligns with the empty PCIe slot. Save this bracket screw, if applicable. Align the HBA to a PCIe slot. Press down gently, but firmly, to seat the HBA correctly in the slot. The following figure shows how to insert the HBA into a PCIe slot. |
