Audited Supplier
XD-80
Washing Machine
Constant Speed
Single-Phase
Driving
Protection Type
4
Direct on-line Starting
ISO9001, CCC
Nanxin
Carton & Pallet
Changshu Jiangsu China
8501400000
Product Description
1.Main Parameters
2.Electrical Characteristic
There is no special requirements, testing regulation in accordance with the JB / T3758, in the normal temperature and humidity (temperature 20± 15ºC, relative humidity 65 ± 20%). During Simulation performance testing, the analog performance of the test shaft should be carried out in a horizontal direction, the noise tests shall be carried out in the vertical axis direction.)
Test Methods
By presenting hearing Same as requirements of noise meter; The scope of the following requirements in operating position will be: Horizontal: ±5° or less,circumferential direction: ±10° or less.
3.Packing
4.Catalog
| Rated Voltage | 220V | Frequency | 50Hz | |
| Capacitor | 11 μF | Output Power | 80W | |
| Number of poles | 4P | Insulation Class | B | |
| End-cover | Galvanized plate | Stator rotor unilateral air gap | ≥0.15mm | |
| Winding Material | Aluminium wire | |||
| Remarks | All parameters can be customized according to customer requirements | |||
2.Electrical Characteristic
There is no special requirements, testing regulation in accordance with the JB / T3758, in the normal temperature and humidity (temperature 20± 15ºC, relative humidity 65 ± 20%). During Simulation performance testing, the analog performance of the test shaft should be carried out in a horizontal direction, the noise tests shall be carried out in the vertical axis direction.)
Test Methods
- Temperature management:Ambient temperature of 20 ºC ± 2ºC before preparatory work place more than two hours
- Load (Dynamometer system simulation load):Load Dynamometer System Simulation
- Load characteristic measurement method:Press dynamometer system testing methods and we need to collect the motor nominal rated power characteristics.
By presenting hearing Same as requirements of noise meter; The scope of the following requirements in operating position will be: Horizontal: ±5° or less,circumferential direction: ±10° or less.
3.Packing
4.Catalog
