Audited Supplier
Bayrich Belt Splice Press for Spindle Tapes, Flat Belt and Machine Belt
★Detail:
Heating presses for bonded splices, can used for Spindle Tape, transmission belts, Tangential Belt, Flat belt etc.
★Features
The joint place is flat, and the thickness of the joint is consistent with that of the baseband.
The joint is firm, and the tensile strength of the joint reaches more than 80% of the original belt.
The joint of the transmission is stable, with little shaking and no noise.
Easy to use portable press for splicing transmission belts, Spindle Tape, Flat belt, Tangential Belt.
We have more than 20 different types small press, pls freely to send us your requirements
Heating presses for bonded splice, (with heating platen on one side), if need double sides heating, pls inform us.
Easy to use and assemble
with fix set temperature, 120 ºC
Portable type
Compact size, it can used in the place where other presses are too big to use
Light weight
Can used for transmission belts, Tangential Belt, Spindle Tape etc.
Quick splicing
★Technical Datasheet
★Product operation and use:
1.Before using the machine, first check whether all parts of the machine are in good condition, and then turn on the power according to the voltage shown on the nameplate of the machine. At this time, the signal red light and green light immediately light up, and the machine panel begins to heat up. When the temperature rises to 95-105 degrees, the green light goes out (the temperature can be adjusted as needed).
2.Coat the polished belt with adhesive, and try to apply it twice. The bonding effect is better. The two times must be dried, pinched and gently placed on the machine panel. There are supports for fixing the belt on both sides of machine. Press the belt tightly with supports, cover the upper pressing plate, tighten with bolts, and remove it after heat sealing, cooling and curing. The belt will be bonded.
3.For temperature regulation, there is a small hole at the bottom of the fuselage with a screw head inside. Rotate it with a slotted screwdriver. Clockwise is for cooling and counterclockwise is for heating. When the new machine leaves the factory, the temperature is set between 95-105 degrees. Generally, users do not need to adjust the temperature by themselves.
4.The hot connection time is generally 20-30min (according to the thickness of the belt)
Other related machine you may need
★Bayrich have verious conveyor belt fabrication machine .Welcome to contact with us.
★Bayrich air cooled press machine in verious industry .
★Bayrich Machine ship to all over the word
