Audited Supplier
BL-003
Yes
1year
Regenerative Thermal Oxidizer
Blue
1-50W
CE
baolanep
Sea Transport
5200*2700*6500
China
Product Description
Regenerative Thermal Oxidizer (RTO) uses the ceramic regenerators to store the heat generated by the decomposition of VOCs, and uses the thermal energy stored in the ceramic regenerator to pre-heat and decompose the untreated VOCs, thereby achieving high thermal efficiency.
System structure
1. regenerator
The regenerator is the heat carrier of RTO system, which directly affects the heat utilization rate of RTO. Its main technical indicators are as follows:
(1) heat storage capacity: the larger the heat stored by the unit volume of the regenerator, the smaller the volume of the regenerator;
(2) heat transfer speed: the thermal conductivity of the material can reflect the speed of heat transfer, the greater the thermal conductivity, the faster the heat transfer;
(3) thermal shock stability: the regenerator switches continuously between high and low temperature for many times. Under the condition of huge temperature difference and short time change, it is easy to deform and break, block the air flow channel, and affect the heat storage effect;
(4) corrosion resistance: the gas medium contacted by the heat storage material is mostly highly corrosive, and the corrosion resistance will affect the service life of RTO.
2. switching valve
The switch valve is the key part of the circulation heat exchange of RTO incinerator. It must switch accurately at the specified time. Its stability and reliability are very important. Because there are a lot of dust particles in the waste gas, the frequent action of the switch valve will cause wear. To a certain extent, the valve will not be tightly sealed and the action speed will be slow, which will greatly affect the use performance.
3. burner
The main purpose of the burner is not to mix the gas and fuel too fast, which will result in local high temperature; however, it can not mix too slowly to cause secondary combustion or even inadequate combustion of the fuel. In order to ensure the combustion of fuel in low oxygen environment, the diffusion between fuel and gas, the mixing with exhaust gas in the furnace and the angle and depth of jet should be considered. These parameters should be accurately calculated according to the actual process requirements at the beginning of design, otherwise it will directly affect the incineration effect of RTO.
