Audited Supplier
1. 1PH, Three-speed Aluminum material cabinet motor, 100% copper wire
2. The modified PP shell, with braked caster, Infrared remote control, open type water distributor
3. Filter the air with pre-dust filters and cooling pads
4. Auto swing: left/right; Manual swing: up/down
5. The temperature display by the temperature sensor
6. Health negative ionizer
7. Water pump protection function against low water level
8. Auto& manual water inlet
Item | Industrial air cooler |
Model Number | JH22AP-HHB |
Dimension | (158+13)*68*111cm |
Power (W) | 550w |
Cooling/Heating | Cooling Only |
Noise | 75 dB |
Cover Area | 100-150sqm |
Control type | Remote |
Water Tank | 120L |
Airflow | 22000m3/h |
Wind speed | 3 speeds |
Q: What places are suitable for water air conditioner portable?
Water air conditioner portable is especially well suited where the air is hot and humidity is low. However, in higher humidity
areas there are many proven cost-effective uses for evaporative cooling that make it the right choice, like poultry farms,
industrial plants, commercial kitchens, laundries, dry cleaners, greenhouses, spot cooling, etc.
Q: What advantages does a water cooling fan have compared to refrigerated cooling systems?
The evaporative air conditioner from china will provide substantial energy saving over refrigerated air units. The
simplicity of the design allows low maintenance requirements. The electric water air conditioner, air cooler without water, and another evaporative air cooler will provide fresh, filtered air. The outside air that has been cooled will blow the stale inside air out.
Q: How often do I clean my pads?
Pads should be cleaned at least once a season before storing them for the winter. In hard water areas, cleaning may be required more frequently. Periodic, visual examination is required. Remove the back or top of the cooler following the instructions in the operating manual. Look at the pads, if they show signs of heavy mineral deposits they will need to be cleaned.
Q: How often should the pads be replaced?
Pads should be changed when they no longer cool as effectively as they did when new. This generally happens when mineral deposits on the pads become so heavy that the water running over them during operation cannot be absorbed. If a pad is properly cleaned and maintained, its life can be three to five years or more. But, we advise the customer to replace the pad every 2 or 3 years to keep the best cooling efficiency.
