Audited Supplier
XLJ02
Automatic Doors, Led Products
Button Battery
Rolling Code
Black, White
433.92MHz
ABS,Metal
50-100m
Universal
3V
Single Item
4buttons
0.040kg
LED Indicator Light
7X4X3cm
No
Learning Code
Wireless Remote Control Button
alzk
Box
box
Guangdong, China
Product Description
remote control
Uses: garage doors, motorcycles, car alarm products, home security products, short-range wireless remote control products,industrial control products
Program to Gate / Garage Door Openers the same way as original DOORHAN Transmitter 4 remotes, please refer to your receiver's user
manual. For a typical DOORHAN Garage Control Panel, the programming procedure is as follows:
1. Press and release the button R on the receiver.
2. The left side of display panel will show 0 then disappears immediately.
3. Press any button twice, coding is completed.
4. Press the transmitter button to test operation.
Note: To remove a single transmitter's code or all transmitter codes from the receiver memory please refer to your receiver
manual.
00:00 00:00
Working voltage | DC6V (2016*2) |
Operating Current | ≤ 8mA |
Working frequency | 433mhz |
Modulation Mode | ASK (AM) |
The transmission power | ≤ 100mW |
Emission Distance | 50 to 100 m |
The encoding type | 301 |
Delete All Codes
1. Turn on the power to DHRE-2 receiver unit.
2. Press CODE button for 10 seconds CODE1 (or SW1) - if you are using CH1, CODE2 (or SW2) - if you are using CH2.
3. LED1 will be flashing 10 seconds then switch off for 2 seconds and flash twice to confirm that the memory is clear.
4. Release the button. All the stored codes including the courtesy light codes should now be deleted. Confirm this by pressing the
transmitters previously used to operate the device. There should be no response.
1. Turn on the power to DHRE-2 receiver unit.
2. Press CODE button for 10 seconds CODE1 (or SW1) - if you are using CH1, CODE2 (or SW2) - if you are using CH2.
3. LED1 will be flashing 10 seconds then switch off for 2 seconds and flash twice to confirm that the memory is clear.
4. Release the button. All the stored codes including the courtesy light codes should now be deleted. Confirm this by pressing the
transmitters previously used to operate the device. There should be no response.
