Audited Supplier
ece 104r reflective tape
Size:50mmm *50y/55mm*50m
Reflective tape we have
ece 104r reflective tape Installation Guide:
The Vehicle have the Protective device,the reflective tape can be stick on the Protective device .If the Vehicle can not stick the reflective tape,should stick the reflective tape on the scale board and install on the car body .
The Place where to stick the reflective tape should clean and remove the greasy,peel off the release paper and stick on the truck and pressed firmly.
1.First ,should spray a little water on the surface then after stick the reflective tape can also remove ,it can made sure the location is correct .
2.Slowly peel off the release paper and push out the bubble when you stick the reflective.
3.If there is very cold and can not sweep the edge ,you can use the heat gun heated and after melting the glue it can be remove
4.To stick the reflective tape on the point need to stick ,made sure the place need stick and then use the scraper or credit card to scrape out the water and bubble or you can used heat gun to made it dry .
5.After stick the reflective tape should keep the car away from water
983 truck reflective tape /film with same quality as Packing:
1)Each one with Polybag packing or box packing,then 24 rolls to a standard carton
2)With standard and hard box packing
3)Blister packing and other packing requirement available
other reflective tape we have
