Audited Supplier
Manipulator Kits
4.8V-6V
7 Microseconds
1.2-1.4kg/Cm(4.8V)
ZEKEEP
Carton Packing
23*22*46cm
China
Product Description
meArm mechanical arm Learn arduino programming and DIY electronics to make discrete UNO maker manipulator kits 
Model:SG90 weight 13g Angle 90 degrees -180 degrees universal Red voltage brown ground wire orange is the signal line
Technical data provided by the manufacturer:
Size:21.5mm*11.8mm*22.7mm
No load speed:0.12 seconds/60degrees(4.8v)
Blocking torque:1.2-1.4kg/cm(4.8v)
Dead zone setting:7 microseconds
Working voltage:4.8v-6v
steering gear, rocker, screws and all accessories
Robot arm motion recording operation:
Press and hold the left button of the remote control board, and then press the restart button of the main control board or shutdown will go off to indicate that the recording state has been added;
Control the state of the mechanical arm through the remote rod, press the left button of the remote rod when reaching the designated position, record the current state, and operate successively;
Press the right button of the remote lever to end the recording, and the mechanical arm will automatically execute the actions recorded before;
Press the left button of the remote control again to stop the automatic cycle and add manual operation mode.
Note: the recorded action will disappear after restart of shutdown, and rerecording will overwrite the previous action.
Suitable for beginners zero base robot
Drag-and-drop graphical programming tools
Diversification can expand electronic modules
Model:SG90 weight 13g Angle 90 degrees -180 degrees universal Red voltage brown ground wire orange is the signal lineTechnical data provided by the manufacturer:
Size:21.5mm*11.8mm*22.7mm
No load speed:0.12 seconds/60degrees(4.8v)
Blocking torque:1.2-1.4kg/cm(4.8v)
Dead zone setting:7 microseconds
Working voltage:4.8v-6v
steering gear, rocker, screws and all accessories
Robot arm motion recording operation:
Press and hold the left button of the remote control board, and then press the restart button of the main control board or shutdown will go off to indicate that the recording state has been added;
Control the state of the mechanical arm through the remote rod, press the left button of the remote rod when reaching the designated position, record the current state, and operate successively;
Press the right button of the remote lever to end the recording, and the mechanical arm will automatically execute the actions recorded before;
Press the left button of the remote control again to stop the automatic cycle and add manual operation mode.
Note: the recorded action will disappear after restart of shutdown, and rerecording will overwrite the previous action.
Suitable for beginners zero base robot
Drag-and-drop graphical programming tools
Diversification can expand electronic modules
