Nebulizer with Mouthpiece/Medical PVC Nebulizer Kit with Mouth

CE/ISO APPROVED Nebulizer with mouth piece

Specifications:
1. Made from clear non-toxic ABS and PVC
2. Nebulizer at angles up to 45° To accommodate special
3. Atomization rate 0.3 ml/min. Drive flow 4 to 8 LPM
4. Atomization particles<5μ

Instructionfor use:
- Place the prescribed medication into the nebulizer jar.
- Carefully snap the lid over the jar.
- Connect one end of the supply tubing to the small stem at the bottom of the nebulizer.
- Attach the nebulizer to the mask inlet or Tee-piece & Mouth piece.
- Connect the remaining end of the supply tubing to the desired pressure source.
- Set oxygen flow to 5-6LPM and check for flow through the device

Caution:
- For single patient use only.
- Not intended for reprocessing.
- Avoid freezing and excessive heat.
- Be sure all connections are secure