Audited Supplier
GY80
CE
PP/PVDF
Pneumatic
Diaphragm
Santoprene, FKM, PTFE, EPDM, NBR
Corrosion-Resistant, Self-Priming, Low Shear
100ºC
5~8m
9.4mm
3 in
3/4 in
1060L/Min
84m
8.4bar
PTFE, PVDF, PP, Stainless Steel, FKM, Santoprene
10000cp
HCMAG
According to Requirements
684mm*417mm*933mm
China
8413709990
Product Description
HCMAG Product Introduction
Welcome your inquiries. HCMAG is wholeheartedly at your service!
| Pneumatic Diaphragm Pump Product Brief | 1. It can pump flowing liquid as well as convey some mediums which are not easy to flow, and has many advantages of self-priming pumps, submersible pumps, shielded pumps, slurry pumps and impurity pumps and other conveying machines. |
| 2,No need to pour water, suction range up to 7m, head up to 50m, export pressure is not less than 6kgf per square centimetre. | |
| 3, flow wide shield, through the performance is good, allowing through the largest particles. Diameter of up to 10mm pumping mud, impurities, minimal wear and tear on the pump. | |
| 4, head, flow can be achieved through the valve opening stepless adjustment. (Air pressure adjustment in 2-8kg/cm2) | |
| 5,The pump has no rotating parts, which will not cause environmental pollution and endanger personal safety. | |
| 6,No need to use electricity, safe and reliable to use in flammable and explosive places. | |
| 7,Can transport the more viscous liquid. (Viscosity below 10,000 centipoise) | |
| 8, the pump does not need oil lubrication, even if idling, the pump does not have any effect, which is a major feature of the pump. |
Welcome your inquiries. HCMAG is wholeheartedly at your service!
