Ramsey Tilt Switch 20-32tilt Switch 20-32 Tilt Sensor

For material flow, blockage and level detection
When a vertically suspended tilt switch is forced to deviate from the vertical position by more than 15 degrees, the mercury contacts inside the switch will act and the normally closed contacts will open. When the external force is withdrawn, the tilt switch returns to the vertical position and the mercury contacts close again. The change of contact opening and closing inside the tilt switch is used to judge the working condition of the protection equipment and take timely measures to achieve the purpose of safety protection.
Features:
The tilt switch can be used as a probe alone or with a control device
Alarm output time is adjustable, with 0-10 seconds adjustable delay line in the control device, which can avoid the tilt switch from instantaneous tilting caused by false action.
Normal/alarm position can be set, there is a jumper in the control device, which can set the switch vertical or tilt state as normal state.
Robust and corrosion resistant
Easy to install
The control unit is a printed circuit board structure and all probes are equipped with mounting accessories.
20-43 Tilt switch controller (imported) 20-38 Tilt switch controller (domestic)
The control unit has an adjustable time delay from 0 to 10 seconds to avoid malfunctioning of the tilt switch probe due to momentary tilting.
Vertical or tilt is selected as the normal state in the control unit by means of a jumper.
Two normally open and normally closed contacts are used for external alarm or control.
Technical Specifications
Power supply: 220 VAC ± 10%, 47 - 62 Hz, 10W
Output: One DPDT contact rated for 5 Amp/220 VAC or 5 Amp/28VDC non-inductive loads
Time Delay: 0-10 seconds adjustable
Jumper: Allows switch vertical or tilted state to be set to normal state
Applications
Chute or adapter blockage detection
Conveyor belt runout detection
Tumbler discharge probes
Detection of missing or unloaded material for belt or vibratory feeders.
Technical specifications
Contacts: Normally closed, mercury switch, 250mA/24 VDC non-inductive loads
Optional: 0.8A at 240VAC/1.5A at 120VAC
Temperature rating: -40°C to +300°C
Housing: Cast iron with nickel-chromium plated finish Tilt angle 15
Tilt switch optional:
Wear plates ---- for material monitoring
Mounting Tube
The Model 20-38 control unit is housed in a NEMA 4X box with front panel indicator lights, green for "normal" and red for "alarm", and an adjustable time-delay circuit of 0-10 seconds in the control unit. An adjustable 0-1O second time delay circuit in the control unit enables the tilt switch to avoid false operation caused by momentary tilting. An internal jumper allows the switch to be set to "normal" for either vertical or tilted conditions. There are a variety of probe assemblies for a wide range of materials and environments, as well as controls without enclosures for fixing in other forms of enclosures and control cabinets.