Audited Supplier
RHP-X
Bridge Type
Resistance Strain
4-Wire
Digital Type
Corrosion Resistant
Integration
Stainless Steel
IP68
CE
Customized
Elevator Car Beam Deformation Load Cell
Measuring The Deformation of The Car Beam
3m
2.0+-0.02%Mv/V
380+/-20 Ohm
352m+/-3 Ohm
4 Wire Blank Cable
5-12V DC
ANT/SUMMIT
Box+Carton, 20PCS/Carton
38X26X31cm
Ningbo China
8431310090
Product Description
ANT RHP-X surface mounting cabin frame load weighing beam strain transducer load sensor by measuring crossbeam deformation.
Strain force sensor: RHP-X
Description:
The strain gauge type pressure link load cell RHP-X typically works with the bending of elevator car steel frame and machine room steel crossbeams ,and it is also widely used for machines and vehicles force measures.Description:
The load weighing Sensor RHP-X measures the load applied on a steel frame by measuring the proportional flexion strain.
Sensor designed for weighing depending on the deformations of steel beams in the motor bed frame or cabin frame.
Easy to install and suitable for any type of beam.
Application:
load limitation on metallic structures, elevation systems (lifts, elevators, freight elevators...).
Field of application: load limitation on metallic structures, elevation systems (lifts, elevators, freight elevators...)
load weighting device for new and modernized elevator cars and beams, for parking systems, cranes, machines tools, load control on vehicles, tank weighting etc.
Determination of weight by measuring the deformation in the weight-bearing structure. This is a cost-effective way to retrofit existing construction, e.g. a silo, with a weight measurement.
Features:
Designed to work on traction and compression,specially for weighing depending on the deformations of steel crossbeams, car frame
- Easy to install and suitable for any type of beam.
- Monitoring of loads at constructions and buildings in order to avoid critical overloading
- Measuring very small strains in rigid structures
| Model | RHP-X |
| Rated Load | Undefined, works with bending steel frame |
| Sensitivity | 2.0+-0.02%mv/v |
| Total error | +/-0.5% F.S |
| Excitation | 5-12V DC |
| Creep Error | +/-0.02% F.S |
| Insulation Impedance | ≥5000 Ohm |
| T C SPAN | +/-0.02% F.S./10 degree Celsius |
| Operation temperature range | -30 to 70 degree Celsius |
| Input Resistance | 380+/-20 ohm |
| Output Resistance | 352+/-3 ohm |
| Construction | Alloy Steel |
| Protection Class | IP68 |
| Cable Length | 3M |
Elevator crossebam deformation load sensor transducer RHP-X Size:
A wide variety ofInstallation options of load sensors on liftThe following installation options are available for the load sensors:
› RHP-X strain link Sensor on car frame
› Multi rope sensor on car after rope clamps ‚
› RH series load sensor on fixed point of individual rope attachment
› UC-AP sensor under elevator car floor …
