Sas False 29p Female Chassis Connector Solder Wire Type Without Bumps No Small 7p 180° Gold Plated 15u'' Wire to Board Connector

1. Basic Information
Model/Prefix: SAS False 29P, where "False" may be a non-standard or product-specific prefix used to distinguish between different models or versions.
Type: Female chassis connector, indicating that this is a female connector designed to be mounted inside a chassis or device and mated with other male connectors.
Pin configuration: 29P, indicating that the connector has 29 pins and is used to make an electrical connection to a corresponding interface on a circuit board or other device.
Connection method: Solder wire type, indicating that the connector uses the soldering method to connect the wires, i.e., the wires are fixed to the connector pins by soldering.
Special description: without bumps, which may mean that the connector surface has no bumps (such as solder posts or pin caps) to minimize interference with other components or to improve the smoothness of installation.
Angle: 180°, which may refer to the angle of the connector pins relative to the connector body, or the angle at which the connector is mounted inside a chassis or device. However, for wire-to-board connectors, this angle description may be less common, unless it refers to the orientation of the connector in a specific application scenario.
Finish: Gold plated 15u'', indicating that the pins or critical contact areas of the connector are plated with a 15 micron thick layer of gold to improve conductivity, oxidation and corrosion resistance.

2. Technical characteristics
High-quality materials: connectors may be made of high-quality copper alloy or other conductive materials to ensure good electrical performance and mechanical strength.
Solder connection: The wires are connected to the connector pins by soldering to provide a stable electrical connection and reliable mechanical fixing.
High Reliability: Gold-plated pins and high-quality material selection contribute to the connector's long-term stability and reliability.
Compatibility: Although the product name refers to SAS (Serial Attached SCSI), it is important to note that SAS is usually associated with specific hard disk interfaces and controllers.

3. Application Scenarios
This connector may be suitable for application scenarios where wires need to be soldered to the inside of a chassis or to a device, such as servers, storage devices, industrial automation equipment, etc.
It may be used to construct internal electrical connections such as power supply, signal transmission, etc.

4. Caution
Be sure to verify the exact model number, specifications and compatibility information of the product before purchase and use.
When installing, follow the installation guidelines and operating procedures provided by the manufacturer to ensure proper installation and reliable connection of the connector.