Maximum climbing angle 55°
Water cooling system
| Smartiger 40 | |||
| ENGINE | HYDRAULICS | ||
| Maker | YANMAR 3-cylinder | Pumps | 3-tandem piston pump1 gear pump (P&G) |
| Type | 4-cycle, Inline, Water-cooled Diesel | ||
| Torque | 107.7 Nm | Driving motors | High torque motor (Poclain) |
| Fuel | Diesel | Flail head motor | High speed motor (P&G) |
| Fuel tank capacity | 28 litres | Independent flail head circuit | Closed circuit piston |
| Combustion system | Direct Injection | Independent track drive circuit | 2x closed circuit piston |
| Gross output | 28.2Kw(38.3Hp)@2600rpm | Independent motions circuit | Opend circuit gear |
| Transmission | Fine control hydrostatic | Oil tank capacity | 23 litres (40 letres held in system) |
| Water-cooled radiator | 2-core heavy duty | Attachment capacity | 750Kg |
| Self-cleaning(optional) | Standard manual andautomatic (optional) | TRACKS | |
| Rubber | Hieghtened teeth rubber track (max working angle 55°) | ||
| REMOTE CONTROL | DIMENSIONS | ||
| Working range | >150m | Overall width (with flail head) | 1500mm |
| Frequency | 434MHZ | Overall width (with flail head) | 2900mm |
| Battery | Interchageable, rechargeableTwo with each unit charge on machine | Overall height (with flail head) | 1300mm |
| Smartiger | 1250kg | ||
| Propotional Joysticks | Standard | Flail head | 20kg |
| PROTECTION AND SAFTY | PERFORMANCE | ||
| Emergency stop | One-touch shut-off switch | Gradient | Working on slopes up to 55° inany direction(alarm at 50° andautomatic shut-off at 55°) |
| Over-slope | Automatic waring(Horn+Light)and shut-off | ||
| Headlamp | LED | Potentiometer speedcontrol (0 to 100%) | 1st gear (low range)Forward and backward 0-4 Km/h2nd gear (high range)Forward and backward 0-9 Km/h |
| Signal loss | Automatic shut-off | ||
| Others | Automatic shut-off if hydraulic oiland lube pressure abnomaly | ||
| Parking | Yes | ||
| Steering | Skid-steering (support pivot-steering) | ||
| Travelling bias correction on slope | Yes | ||
| ATTACHMENT / FLAIL HEAD (STANDARD) | |||
| Standard attachment | Flail head | Rotor width | 1350mm |
| Oil flow | 84L/min | Rotor diameter | 300mm |
| Pressure | 250bar | Cutting height range (via roller adjustment) | 30mm-90mm (3 positions) flail can be lifted to cut higher than 90mm |
| Rotor speed | 3000rpm | ||
| Front and rear flap | Chain and rubber | Hydraulic lift | -200mm to 500mm |
| Flails | Y-Flails for grass cutting and ligh wood up to 30mm diameter | Auto-float capacity | Yes (follow groundcontour up-down 10°) |






Mower Branch Crusher
Heavy Duty Trenching Fork












Audited Supplier










