Audited Supplier
BZ-C Cable Cleat
RoHS, Short Circuits
Metallic
Electroplating
Electrical Appliance
Stainless Steel
U Type
XIXI
Carton
17~129mm
China
73269090
Product Description
| Product Information: | ||||
| •Device designed to provide securing of cables when installed at intervals along the length of cables | ||||
| •For fixing, retainning, supporting & securing cables in trefoil or single formation. | ||||
| •Protecting cables from short circuit faults(see detail information below) | ||||
| Short circuit current is an overcurrent resulting from an electrical fault of negligible impedance between live | ||||
| conductors or between a live conductor and an earth, having a difference in potential under normal operating | ||||
| conditions. | ||||
| - RMS current is a calculated value for the initial cycles of the fault. | ||||
| - peak(ip) short circuit current is a maximum possible instantaneous value of the short circuit current. | ||||
| - Electromechanical Force(Ft) is included forces acting on current carrying conductors. | ||||
| - Relevant Standard : BS EN 50368 & IEC 61914 : 2015 | ||||
| a. Cable Cleats and intermediate restraints shall comply with the performance requirements in Article 398.2(d) | ||||
| of NFPA-70-2005, The National Electrical Code Cable Cleats and intermediate restraints (where used) shall | ||||
| be classified, tested and certified according to the European Specification IEC 61914 : 2009, Cable Cleats | ||||
| for Electric Installations, as follows | ||||
| i. Classified according to material as Metallic, or Composite (e.g. metallic Cable Cleat with an LSF liner) | ||||
| ii. Classified according to resistance to impact as 'Very Heavy'(i.e. 20J impact energy @ 400mm height) | ||||
| iii. Classified by an independent third-party testing laboratory in relation to resistance to electromechanical | ||||
| forces as video: | ||||
| sustaining two successive short circuits and there shall be no cuts or damage to the outer cable sheath, | ||||
| and the cables shall meet the requirements of the voltage withstand test) | ||||
