Audited Supplier
Features of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
Torque 32NM
2 or 3 points
Actuator and damper shaft are bolt-on by screw.
Maximum round shaft φ20 and square shaft 16*16mm.
Direction of rotation can be setting.
Manuel Override
With 2 auxiliary switches are optional
Power supply AC/DC 24V or AC 230V
S6061-32D outline and mounting dimension
Technical datasheet of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
Item | Unit | S6061-32DN(F) | S6061-32DN(F) | |
Torque | Nm | 32 Nm | ||
Damper area | m2 | 6 m2 | ||
Running time | sec | 114~138 | ||
Power supply | V | 24VAC/DC | 220VAC | |
Frequency | Hz | 50/60 7.5W 50/60Hz | ||
Running consumption | W | 4.0W | 5.5W | |
Maintaining consumption | W | 0.5W | 1.0W | |
Weight | Kg | 1.25Kg | ||
Control signal | 2/3 point | |||
Rotation angle | 0~90º(Max 93°) | |||
Limited angle | 5~85º(Per step 5º) | |||
Auxiliary switch rating | 3(1.5)Amp 250V | |||
Life cycle | >70000 cycles | |||
Noise level | 45dB(A) | |||
Electrical level |
| |||
Protection level | IP44 or IP54 | |||
Ambient Temperature | -20~+50ºC | |||
Ambient Humidity | 5~95%RH | |||
Storage temperature | -40~+70ºC | |||
Certificate | CE UL(Except 230V) | |||
Remark: After lead to the actuator wire through PG joint, the protection level can reach IP54.
Wiring diagram of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
Auxiliary switch of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
There are two auxiliary switches of S6061-32DF damper actuator, can set the angle 0-90° (factory sets 10° and 80°), it will show a signal when the actuator turns to the setting angle.
Angle of rotation limiting of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
The rotation angle or working range of the actuator can be adjusted 5°by adapter so that can limit mechanically. You just press the locking clip to lose the adapter.
Control signal and choose the rotate direction of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
Factory setting:
Switch an at 10° Switch b at 80° The switching position can be manually changed to any required position by turning the ratchet.
Must make the contact pin(C) in as Same direction as motor plug.
Outline dimension of S6061-32D Standard Damper Actuator (Non Fail-Safe Damper Actuators)
