Audited Supplier
TD-AA1100H
Rubber
Cone Type
Solid
1100h
Inland and Coastal Boats
Fender, Bumper
Ship Launching, Protection
BV, ISO9001, CCS
TIANDUN
Container
CE, SGS, BV, Lloyd's, ISO9001, H1100
Qingdao, China
Product Description
Competitive Advantage:
1. The energy absorption doubles comparing with the super cell rubber fender with same spec.
2. In the case with similar reaction force and energy absorption, small size TD-AA cone type fender can substitute relative large TD-A super cell type fender.
3. In the case of oblique berthing (less than a angle of 10° ), the performance can not be reduced, which is preferred to TD-A model.
4. The frontal frame (steel frame) are installed in front of fenders, which can reduce the surface pressure against vessel hull. The surface can be limited below 25t/m2, which is suitable to large vessel especially.
5. The super high density polyethylene pads are adhered to the frontal frame, which can reduce the friction factor between hull and fender to below 0.2, and can reduce the shear (horizontal force) exerted on fenders when vessel berth, which can prolong the service life of fenders.
Description:
L Wide range of sizes
L PIANC tested and certified
L Standard and intermediate rubber grades
L High efficiency
L Good angular performance
TD-AA cone type rubber with cone shaped rubber and frontal mount steel frame is the 3rd generation product of cell type rubber. Adopting cone rubber and full-new structure design of preposed steel structure, it is one of most excellent performance fender in that designed compress deformation rise from 52.5% to 70% if reaction force do not increase. Its emergence simplifies wharf structure and reduces the cost of quay wall construction, hence it is and ideal substitute of cell type rubber fender.
1. The energy absorption doubles comparing with the super cell rubber fender with same spec.
2. In the case with similar reaction force and energy absorption, small size TD-AA cone type fender can substitute relative large TD-A super cell type fender.
3. In the case of oblique berthing (less than a angle of 10° ), the performance can not be reduced, which is preferred to TD-A model.
4. The frontal frame (steel frame) are installed in front of fenders, which can reduce the surface pressure against vessel hull. The surface can be limited below 25t/m2, which is suitable to large vessel especially.
5. The super high density polyethylene pads are adhered to the frontal frame, which can reduce the friction factor between hull and fender to below 0.2, and can reduce the shear (horizontal force) exerted on fenders when vessel berth, which can prolong the service life of fenders.
Description:
L Wide range of sizes
L PIANC tested and certified
L Standard and intermediate rubber grades
L High efficiency
L Good angular performance
TD-AA cone type rubber with cone shaped rubber and frontal mount steel frame is the 3rd generation product of cell type rubber. Adopting cone rubber and full-new structure design of preposed steel structure, it is one of most excellent performance fender in that designed compress deformation rise from 52.5% to 70% if reaction force do not increase. Its emergence simplifies wharf structure and reduces the cost of quay wall construction, hence it is and ideal substitute of cell type rubber fender.
Rubber grade Performance | Rated deflection 70% | Maximum deflection 72% | ||
| Reaction Force (KN) | Energy absorption (KN@M) | Reaction force (KN) | Energy absorption (KN@M) | |
| Super high reaction force (P2) | 1400 | 801 | 1568 | 832 |
| High reaction force (P1) | 1120 | 638 | 1265 | 664 |
| Standard reaction force (P0) | 886 | 498 | 1014 | 518 |
| Low reaction force (P01) | 707 | 375 | 818 | 387 |
