Textile Use Anti Statics Device Statics Reducer Remover

WAREHOUSE PICTURES


Characteristics of eliminator
1. High voltage output transformer adopts dry type
2. It has the advantage of no spark discharge and can output short circuit for a long time
Installation method
The electrostatic elimination equipment is composed of two parts: one electrostatic eliminator and 1-2 electrostatic rods, both of which have good effects. quiet
The electric eliminator and the electrostatic eliminator are connected by a high-voltage line, and the host generates a high-voltage and sends it to the electrostatic eliminator,
It can eliminate electrostatic interference caused by object friction in the production process.
Use and maintenance
1. The power supply of the eliminator is 220V. It is forbidden to use 380V. During use, the terminal should be reliably connected to the metal of the machine
The machine body and the ground are connected, otherwise the eliminator may be damaged.
2. The grounding terminals at both ends of the discharge rod shall be reliably grounded, and the discharge pin shall be vertically aligned with the electrostatic object. The closer the distance is, the electrostatic elimination effect will be achieved
The better the result.
3. When the machine is working, the operator must not touch or approach the discharge needle at the high-voltage output end.
4. The high-voltage output line shall be separated from the grounding line by a certain distance and shall not be close to any metal object.
5. The discharge rod shall be cleaned frequently. In particular, there shall be no sundries or cotton wool between the aluminum alloy and the discharge needle to avoid prolonged use
The rod and the box were damaged by the fire.
matters needing attention
The electrostatic elimination host and the electrostatic rod must be reliably grounded and connected to the rack (metal material)!!! Otherwise, it will affect
The effect of removing static electricity will cause short circuit damage between the main engine and the rod. The high-voltage wire on the electrostatic rod cannot be tied with the grounding wire
To avoid short circuit.