Audited Supplier
| Model number | S900-1200-1400-1650-240 |
| The cavity type | tough thick;thick;thin |
| Weight | 55t |
| Minimum drainage ore outlet | 3/1" (9mm)~11/2" (38mm) |
| The size of the feeding port | 35/6" (83mm)~131/4" (334mm) |
1.New special design,simple and reasonable structure,smooth and stable running and low operation cost.
2.Hydraulic adjustment devices,convenient to adjustdischarge opening size.3.Hydraulic release system consists of several hydrauliccylinders.
4."Spring type"over-load protection.This release systemallows uncrushable materials to pass through
1. Bearing for the full load of the machine, so good lubrication of bearing life, it directly affects the service life and operation rate of the machine, thus requires the injected lubricating oil must be clean, sealing must be good, the main oil injection of the machine, rotating bearings, roller bearings, all gears, movable bearings, sliding plane.
2. The newly installed wheel hoop is prone to loosen and must be checked frequently.
3. Pay attention to whether all parts of the machine are working normally.
4. Pay attention to check the wear degree of the easily worn parts, and pay attention to replace the worn parts at any time.
5. Put the bottom plane of the bottom frame of the moving device, and the dust and other objects should be sent out to avoid the moving bearing can not move on the bottom frame when the machine encounters the material that cannot be broken, resulting in serious accidents.
6. If the bearing oil temperature rises, stop and check the cause immediately.
7. If there is an impact sound when the rotating gear is running, it should immediately stop to check and eliminate it.
