Audited Supplier
Nylon Elastomer
Nylon elastomer is TPAE, TPAE inclued PEBA,PEEA,PEA according to the monomer.
The nylon Elastomer, high impact strength, Shore D63. even at -50ºC lowtemperatures, It can be used for molding injection, extruding and compoundpolymer. It could maintain good performance at very wide rangetermperature.
Best Price Virgin Polyamide PA12 Granular Nylon Elastomer for Injection Molded Sports Shoes
Typical Characteristics:
• Good and consistent behavior at cold temperature
• No mechanical property loss during repeated solicitation and resistance to fatigue (low hysteresis, high energy transfer and no heat build up)
• Excellent spring back and elasticity return
• Accurate dimension stability
• The Lightest Thermoplastic Elatomers PA12 Elastomer
| TYPICAL PROPERTIES TYPE of Shore D63 | |||
| Charpy Notch Impact | KJ/m2 | ISO179 | 25JNB |
| Charpy Non-Notch Impact | KJ/m2 | ISO179 | 25JNB |
| Tensile Strength | MPa | ISO527 | 28 |
| Elongation At Break | % | ISO527 | 310 |
| Flexural Strength | MPa | ISO178 | 10 |
| Flexural Module | MPa | ISO178 | 228 |
| Density | g/cm3 | ISO1183 | 1.03 |
| Water Content | % | <0.2 | 0.15 |
| Hardness shore | Shore D | ISO868 | 63 |
| Melt Point | ºC | GB 4608-84 | 182 -186 |
