Audited Supplier
TC2030-FTDI-TTL-232RG-VREG3V3 USB to TC2030 Serial Cable
FTDI's TTL-232RG-VREG3V3 to USB Serial Converter cable fitted with a TC2030 6-pin "Legged" Tag-Connector
Description:
This product is FTDI's TTL-232RG-VREG3V3 to USB Serial Converter cable fitted with a TC2030 "Legged" Tag-Connector. This tiny footprint TC2030 debug connector requires no mating-half connector on the PCB saving target board cost and space.
Specification:
VCC: 3.3V
VCC Max current: 250mA
UART TTL level signals: 3.3V
Data rates: 3Mbps
Nominal cable length: 5.9ft/1.8m
See also the no-legs version TC2030-NL-FTDI-TTL-232RG-VREG3V3. For details of the full range of Tag-Connect FTDI test cables , see the FTDI test cables range summary and full list of available FTDI family cables.
| TC2030 pin | FTDI Signal | Type | Description |
|---|---|---|---|
| 1 | VCC (RED) | Output | Power supply output |
| 2 | CTS / TMS (BROWN) | Input | Clear to Send Control input / Handshake signal |
| 3 | RXD / TDI (YELLOW) | Input | Receive Asynchronous Data input |
| 4 | TXD / TCLK (ORANGE) | Output | Transmit Asynchronous Data output |
| 5 | GND (BLACK) | GND | Device ground supply pin |
| 6 | RTS / TDO (GREEN) | Output | Request To Send Control Output / Handshake signal |
TTL-232RG-VREG3V3-WE Cable, TTL to USB Converter, Wire-End, 3V3, 1.8m
Product Overview
The TTL-232RG-VREG3V3-WE is an USB to UART cable with +3.3V TTL level UART signals incorporating FT232RQ USB to serial UART interface IC which handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with a logic level serial interface to USB. It contains a small internal electronic circuit board, utilising the FT232R, which is encapsulated into the USB connector end of cable. The other end of cable is wire ended. The cables can be used for TTL or interface logic over a range to voltage levels. The USB side of the cable is USB powered and is USB 2.0 full speed compatible. The cable is 1.8m long and supports a data transfer rate up to 3Mbaud. It supports the FTDIChip-ID, with a unique USB serial number programmed into the FT232R. This feature can be used to create a security or password protected file transfer access using the cable. This cables require USB drivers, which are used to make the FT232R in the cable appear as a virtual COM port.
- Maximum output of 250mA on VCC
- USB 2.0 (12Mb/s) full speed compatible
- Connect directly to a microcontroller UART or I/O pins
- UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd/even/mark/space/no parity
- Internal EEPROM with user writeable area
- UHCI/OHCI/EHCI host controller compatible
- Voltage output power allows external logic to be powered from the USB port
- Entire USB protocol handled by the electronics in the cable USB
- Six way outputs provide Tx, Rx, RTS#, CTS#, VCC and GND
- Low USB bandwidth consumption
Applications
Communications & Networking, Sensing & Instrumentation, Industrial, Security, Automotive
