Audited Supplier
• Piercing connector, simple installation, need not strip the cable coat.
• Moment nut, piercing pressure is constant, keep good electric connection and make no damage to lead.
• Adopted special connecting tablet, apply to joint of Cu (Al) and Cu (Al) or Cu and Al.
• Small electric connecting resistance,connecting resistance less than 2.5 times of the resistance of branch.
• Special insulated case body, resistance to ilumination and environmental aging, the insulation strengthcan up to 12kv.
• Arc Surface design, apply to connection with the same (different) diameter, wide connection scope(0.75mm2-400mm2/ td)
Features
Made of hard, corrosion resistant aluminum alloy
Tested according to international and many national standards
Teeth either of pure aluminum or tin-plated aluminum
Construction
Component:Material
Body:Tin coated corrosion resistant aluminum alloy
Washer:Conical spring washer
Screw:Hot dip galvanized
Cover:Weather and UV-radiation resistant plastic
Installation:Remove conductor inlet caps according to the connection to be made. Open the upper lid.Unscrew the screw until the conductors can be placed into the connector. Tighten the screw until the shearhead breaks. Shut the upper lid.
1.Adjust the connector nut tosuitable location.
2.Put the branch wire in to thecap sheath fully.
3.Insert the main wire if there are two laysof insulated lay in the main cable, shouldstrip a certain length of the first insulatedlay from inserted end.
4.Turn the nut by hand, and fix the connector in suitable location.
5.Screw the nut with the sleeve spanner.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
