5kV 8kV SHD-GC EPR Insulation Rubber Cable MV 3X4/0AWG Mining Cable

Conductor:

• 6 AWG thru 500 kcmil coated annealed copper, bunched wires, rope-lay stranded per ASTM B172

Extruded Strand Shield (ESS):

• Extruded thermosetting semiconducting stress control layer over conductor

Insulation:

• Ethylene Propylene Rubber (EPR) insulation colored for contrasting with black conducting layers

Insulation Shield:

• A flexible coated copper/textile braid shield is applied over a non conducting overlapped tape

Ground-Check Conductor:

• Annealed copper, rope-lay-stranded per ASTM B172, insulated with EPR and glassbraid

Features:

• Simultaneous extrusion and vulcanization of both strand shield and insulation form a virtually perfect electrode, eliminating unequal electrical stresses
• Excellent heat, moisture, steam, oil, corona, chemical and radiation resistance
• Flexible for easy handling
• High dielectric strength
• Electrical stability under stress
• Low dielectric loss
• Resists cutting, impact, abrasion, flame and sunlight
• Excellent thermal stability and physical properties over a broad temperature range
• Two-layer jacket is reinforced to provide maximum protection from mechanical damage-the cause of most portable cable failures

Compliances:

• ICEA S75-381 Portable and Power Feeder Cables for se in mines and similar applications
• Meets flame test requirements and is accepted for listing by MSHA
• Approved by the Pennsylvania Department of Environmental Protection
• Meets CAN/CSA-C22..2 No. 96 Portable Power Cables.

Packaging:

• Material cut to length and shipped on nonreturnable reels