Oxygen sensor bung adapter CEL eliminator with mini catalytic converter inside
Stainless Steel 304 mini catalyst O2 Oxygen Sensor Lambda Extender Spacer M18X1.5 with E3In vehicles with EURO 3 and higher vehicle emissions standards the second lambda oxygen sensor emulator is located after the
catalytic converter.
It plays a diagnostics role. If it detects any irregularities on the basis of the data from the engine control unit it displays an
error on the dashboard (a popular "CHECK ENGINE") and the engine can switch into emergency mode (depending on the make of car). It
is often manifested by big power drop. These problems arise in the event of removal of the catalyst, its low efficiency, or its
replacement with jet pump.
In such situations, it becomes necessary to mount THE SECOND LAMBDA OXYGEN SENSOR EXTENDER. The catalyst can effectively reduce
the power output of 2 to 3%, and the maximum power speed of up to 5%.
Its removal and the use of emulator is the easiest way to low-cost raise of power. The emulator can also help in case of problems
with the LPG installation, which due to the detection of very rich mixture will display the CHECK ENGINE on the dashboard.
Item Name | M18*1.5 Oxygen Sensor CEL Eliminator Adapter Spacer With Catalyt Converter |
Material: | SS304 and stainless steel ternary catalysis |
Size: | hexagon 22mm, length 55mm. Inner diameter thread M18*1.5 |
Weight: | 76g-R01, 221g-R02 |







