Audited Supplier
Input signal can make compatible with TTL,CMOS etc logic circuit.
Direct copper bonding(DCB)technology
Opto-isolation over than 4000VACrms
Switching method:zero-crossing &Triac Angle trigger.
LED indication.
Build-in resistance-capacitance absorption circuit.
Actuation time:ON<10ms/OFF<10ms
Clip-on IP20 protective cover.
Model | SSR-VA-H | ||
Load Current | 10A,15A,25A,40A,60A,75A,90A | ||
Load Voltage | 24-380VAC,90-480VAC | ||
Control Mode | VR:500KΩ/220VAC,1MΩ/380VAC | ||
Dielectric Strength | 2000VAC | ||
Insulation Resistance | 500MΩ/500VDC | ||
1. Before you use , read safety precautions carefully, and use this product properly.
2. do not touch or contact the input/output terminals because they may cause electric shock.
3. The user must install the external safety equipment when there are possible defect of this product or serious accidents.
4. To prevent defection or malfunction of this product, supply proper power voltage in accordance with the rating.
5. To prevent electric shock or devise malfunction of this product, do not supply the power until the wiring is completed.
6. Reassemble this product while the power is off. Otherwise, it may cause malfunction or electric shock.
7. If the user use the product with methods other than specified by the manufacturer, there may be bodily injuries or property damages.
8. Due to the danger of electric shock, use this product installed onto a panel while an electric current is applied.
1. Before using the product you have purchased, check to make sure that it is exactly what you ordered.
2. Do not use this product at any place with corrosive ( especially noxious gas or ammonia) or flammable gas.
3. Do not use this product at any place with liquid, oil , medical substances, dust , salt or iron contents.(pollution level 1 or 2 )
4. Do not use this product at any place with excessive induction trouble, static electricity or magnetic noise.
5. Do not use this product at any place with possible thermal accumulation due to direct sunlight or heat radiation.
6. When the product gets wet, the inspection is essential because there is danger of an electric leakage or fire .
7. Do not connect anything to the unused terminals.
8. For dc types, connect wires at the correct position after checking polarity of terminal.
9. The rated heat sink must be used , otherwise , the product may be destroyed.
10. When product is disposed , treat as a industrial waste.
