Jiecheng EPE Foam Board Production Line

Jiecheng EPE Foam Board Production Line
1. We are the only one manufacturer
2. Passed CE, ISO
3. One layer thickness reach to 100mm, saving labors and time
4. Density: 18-22kg/m3


Product Introduction
Equipped with Frequency conversion soft start-up device, and this will save 30% electricity than the similar one; Applied PLC and
Solid-state no spark heating control technology for temperature control, safe and stable; Adopted 12HP dual-system, dual-cold and
High pressure cold planish machine in cooling control system; Applied oil heating and cooling design to the screw to decrease scale,
Extend devices service time, save water, and no longer use recycling water; With dual-vacuum online pinhole mounting hole endothermic
And special design for board cutting control system, it integrated producing and edge trimming in one, convenient for operating,
Controlling and reducing the space; Adopted solid-state electrical components to reduce electrical dielectric; Screw design applied
Hot-pressing, double pulls, and supercharge to the screw tubes, then increasing materials mixing time inside barrel and reducing
The friction factor and shear force between materials and barrel. By increasing inner pressure, it can strengthened materials density
Performance and tensile strength. The main improvement of screw barrel is changing the original loop cooling and groove, wears hot
Jacket to the barrel surface, this technology has increased 3/4 of the work load for the machining of screw barrel; Transmission control
System applied roll cylinder, double led three-roll calender and telescopic guide roller automatic conveying, then reducing the friction
On the roller surface, make sure the inner and exterior cell of the board homogeneous.