Audited Supplier
LK-BL2210F
Main features
It can be connected with an external speed display board LK-BL01, showingthe speed, set drive parameters;
It has high speed output with the maximum speed of 10000rpm / minSpeed control mode : analog quantity 0-5V
It has have EN, DIR signal control side;
It can output tachometer pulse (optoelectronic isolation, gate output);
It has over-current, overvoltage, under voltage , overheating, motor stalling and other protection functions
Product Overview
LK-BL2210F is the latest high-tech product of our company, for the field of medium power motor drive. It uses a large-scale integrated circuit to replace the original hardware, so it has higher performance of anti-jamming and fast response ability. It is suitable for all the low voltage three-phase brushless DC motors with peak current below10A and low voltage AC80V-250V(boards show AC80V-220V) ,whether the motor driver with Hall or not. It is widely used in knitting equipment, medical equipment, food packaging machinery, electric tools and a series of electrical automation control area .
Function as following: (default setting mode: Square wave, Hall, Open loop)
1.Run model: square wave, with hall sensor, open loop speed
2.Run model: square wave, with hall sensor, closed loop speed
3.Run model: square wave, without hall sensor, open loop speed
4.Run model: square wave, without hall sensor, closed loop speed
5.Run model: constant-torque device, open loop speed(Don't run for long time with overloading)
6.Run model: constant-torque device, closed loop speed(Don't run for long time with overloading)
On the basis of our upper computer software and hand debugger, all the above functions can be set by yourself
Power supply | AC80V~220V direct current (Capacity according to motor power selection) |
The maximum input current | Not greater than10A (according to motor and rated load) |
The maximum power | The maximum is 2200W (over power motor is strictly prohibited) |
Adaptable motor | Adaptable output power ≤1500W motor |
Insulation resistance | General temperature>500MΩ |
Insulation strength | General temperature and pressure 0.5KV,1minitute |
Environmental Parameter
Cooling method | Natural air cooling & forced air cooling | |
Environment | Condition | Avoid dust, oil mist and corrosive gases |
Temperature | 0ºC~+50ºC | |
Humidity | <80%RH,no condensation, no frost | |
Vibration | 5.9m/s2 max | |
Reserved temperature | -20ºC~+65ºC | |
Size | 198mmX103mmX86mm | |
Weight | About 1Kg | |
Safety attention
The motor and drive wiring must be connected in the power-off state. Do not connect electrical wiring under power.
According to the illustrated method, connect the power cord, motor winding wire and Hall signal line correctly. Please pay attention to the order of UVW three-phase must be consistent.
Do not disassemble the drive at random to prevent damage.
Do not touch all terminals on power-on state.
Do not drive without shell operation
Impact of the drive may cause damage.
If you need Hand-held Intelligent Debugger,pls click it.
