Microcomputer High-Speed Paper Roll Slitting Machine (QFJ-1300)

The machine is mainly used to slit stick paper, craft paper and other kinds of paper

(Main Technical Parameter )
1, The rang of gram weight: 50-400 g

2, The cutting width: 50-1050mm

3, The diameter cutting is less than 1300 mm

4, Finished specification width: 50/200mm, the diameter of paper is less than 1100mm, After the cut end deviation 1mm, Paper

5. The deviation of cutting width: 0.5mm

6, The speed of operation: 0-150m/min

7, The suitable material: 50-400 g

8, The rang of rewinding: From 50mm-1200mm within could adjust, the circular knife is 14 sets(including upper knife and down knife ).

9, The mode of taking-up equipment: It adopts double rewinding shaft, it could choose different roll according to your requirement! It is equipped with air-expansion ( 2 pieces of 3 inch air-expansion rewinding shaft )

10, In the system: Correct an error to make sure good condition, also the scrape edge is 3-8mm

11, The unwinding parts: It could adjust from left to right, the air-expansion shafts is hard to make sure handing is safe and convenient!

12, Feeding tension control: 20kg magnetic powder control

13, Automatic count meter, alarm and halt equipment, the whole is equipped with safe signal and shield to make sure operate safety

14, The mainframe adopts 3.7kw stepless frequency speed regulation is 0-150m/min( it could adjust according to different material )

15, The whole adopts superior steel plate ( thickness is 30mm) and channel steel structure, slide adopts linear bearing

16, It adopts the dia is 100mm dynamic balance

17, The rewinding parts: It is adopted double torque motor control, the dia of rewinding is less than 1100mm.