Audited Supplier
1. Parker Denison pump T6 Single Vane Pump
2. Model T6E, T6ER, T7ERS, T6ERM T7ES, T6EM T7ES, T7BS T7E T7ES T7DS T7DRS,
T6C, T6CM T6CR T6CRM T6CRM T6CR,
T6D, T6DM T6DR, T6DMY T6DRMY T6DRM
3. Interchangeable Vane Pump cartridge displacement as follow:
T6C vane pump: 003, 005, 006, 008, 010, 012, 014, 017, 020, 022, 025, 028, 031
T6D vane pump: 014, 017, 020, 024, 028, 031, 035,038, 042, 045, 050
T6E vane pump: 042, 045, 050, 052, 057, 062, 066, 072, 085
T7E vane pump: 042, 045, 050, 052, 057, 062, 066, 072, 085
T6c T6cm T6crm T6cr T6cy T6d T6ds T6dm T6em T6emy T7ey T7emy T7bs T7dbs T7dy
4. Feature below.
The high pressure vane pump incorporates the design of vane pin holdout.
They are applicable for those hydraulic machineries that demand high rotation pressure and low noise level.
The vane pump series are designed for applications in die casting machines, injection molding machines and other special construction equipments.
Hydraulic fluid: Before starting project planning, please refer to our data sheets RE 90220 (mineral oil), RE 90221 (environmentally acceptable hydraulic fluids) and RE 90223 (HF hydraulic fluids) for detailed information regarding the choice of hydraulic fluid and application conditions.
The correct choice of hydraulic fluid requires knowledge of the operating temperature in relation to the ambient temperature: in an open circuit the tank temperature. The hydraulic fluid should be chosen so that the operating viscosity in the operating temperature range is within the optimum range - the shaded area of the selection diagram. We recommended that the higher viscosity class be selected in each case. Example: At an ambient temperature of X°F (X°C) an operating temperature of 140°F (60°C) is set. In the optimum operating viscosity range (shaded area) this corresponds to the viscosity classes VG 46 or VG 68; to be selected: VG 68.Please note: The case drain temperature, which is affected by pressure and speed, is always higher than the tank temperature. At no point in the system may the temperature be higher than 240°C (115°C) for sizes 5 to 200 or 195°F (90°C) for sizes 250 to 500.If the above conditions cannot be maintained due to extreme operating parameters, we recommend flushing the case at port U (size 250 to 500).
