Audited Supplier
SHBYCM
Photodegradable
632-51-9
C26h20
632-51-9
TPE
General Plastics, Engineering Plastics, Specialty Plastics
Thermoplastic Plastics
Injection
Bean Grey
TPE
TPE for Membrane Filter Press Plate
Boyan
25kg/Bag
25kg
China
39021000
Product Description
TPE compound based on Styrenic Block Copolymer (SBC). This material can be over-molded onto PP or used for single molding. This grade is designed for injection molding. It is completely recyclable.
Technical Property
The data are not to be defined as specifications.
Notes:
1) The product is incompatible with PVC. Purge thoroughly before and after use of this product with a low flow (0.5 - 2.5 MFR) Polyethylene (PE) or Polypropylene (PP).
2) Color concentrate with PP, LDPE or EVA based carrier is recommended.
3) Drying is not required. However, if moisture is a problem or to get better appearance, dry pellets for 3 hours at 600C.
| General | |||
| Appearance | √Translucent | ||
| Feature | √Soft Touch | √ Easy Coloring | √Tear Resistance |
| Compliance | √ RoHS | √ REACH | √ FDA |
| Form | √ Pellet | ||
| Packaging | √25kg/bag |
| Typical Properties | Typical Value | Unit | Test Method |
| Hardness | 85 | Shore A | ASTM D2240 |
| Density | 0.89 | g/cm3 | ASTM D792 |
| Tensile Strength at break | 15.5 | MPa | ASTM D412 |
| Tensile Strength at 100% | 4.4 | MPa | ASTM D412 |
| Elongation at Break | 713 | % | ASTM D412 |
| Tear Strength | 59 | KN/m | ASTM D624 |
| Compression Set at 23ºC x 22hr | 26 | % | ASTM D395B |
Notes:
1) The product is incompatible with PVC. Purge thoroughly before and after use of this product with a low flow (0.5 - 2.5 MFR) Polyethylene (PE) or Polypropylene (PP).
2) Color concentrate with PP, LDPE or EVA based carrier is recommended.
3) Drying is not required. However, if moisture is a problem or to get better appearance, dry pellets for 3 hours at 600C.
