Pulp Paper Bactericide Bacteria Paper Making

1. Product Identification

• Product Name: Bactericide  1689
• Type: Broad-spectrum liquid bactericide
• Appearance: Light green to blue clear liquid
• CAS No.: [combinationed]
• Manufacturer/Supplier: Longkey Chemistry Limited

2. Composition/Ingredients

Note: Full ingredient disclosure is proprietary. For safety data, refer to Section 7.

3. Physical & Chemical Properties

• pH Range: 2.0-4.5
• Density: 1.0-1.2 g/cm³
• Solubility: Fully miscible in water
• Storage Temperature: <30°C (cool, dry place)
• Shelf Life: 12 months
• Values are typical and not for quality control.

4. Applications & Dosage

4.1 Usage Scenarios

• Wet-end pulp preservation:
  • Dosage: 50-200 ppm
  • Frequency: Intermittent addition
• Coating system preservation:
  • Dosage: 300-500 ppm
  • Frequency: Continuous or pulsed
• Slime control (per ton of paper):
  • Dosage: 50-150 g/ton
  • Frequency: Process-dependent

4.2 Methodology

• Feeding System: Diaphragm pumps with Teflon/PVC/316 stainless steel components.
• Injection Points: Add to well-mixed zones in pulp or coating systems.
• Optimization: Adjust dosing based on microbial load (monitor via ATP testing).

5. Handling & Storage

5.1 Packaging

• Standard Units: 200 kg polyethylene (PP) drums or 1000 kg IBCs.
• Container Capacity: 22 metric tons per 20ft container (IBC only).

5.2 Storage Requirements

• Avoid direct sunlight and moisture.
• Keep containers sealed to prevent evaporation/contamination.

5.3 Transportation

• Regulatory Status: Non-hazardous per IMDG/IATA/ADR.
• Special Notes: Secure containers to prevent leakage during transit.

6. Health, Safety & Environmental Data

6.1 Hazard Identification (GHS)

• H318: Causes serious eye damage.
• H412: Harmful to aquatic life with long-lasting effects.

6.2 Exposure Controls

• PPE:
  • Safety goggles with side shields.
  • Nitrile gloves and chemical-resistant apron.
  • Respiratory mask (if ventilation is inadequate).
• Engineering Controls: Local exhaust ventilation in handling areas.

6.3 First Aid Measures

• Eye Contact: Rinse immediately with water for ≥15 minutes; seek medical help.
• Skin Contact: Wash with soap and water; remove contaminated clothing.
• Inhalation: Move to fresh air; administer oxygen if needed.
• Ingestion: Do NOT induce vomiting; rinse mouth and consult a physician.

6.4 Spill Response

• Contain with inert absorbents (e.g., sand, vermiculite).
• Collect residues in sealed containers for hazardous waste disposal.

6.5 Environmental Precautions

• Prevent entry into sewers or waterways.
• Neutralize spills promptly to minimize ecological impact.

6.6 Disposal

• Treat as industrial hazardous waste.
• Dispose via licensed facilities complying with local regulations.

7. Disclaimer

The information herein is provided in good faith and based on current knowledge. Users must verify suitability for specific applications. For full safety details, consult the Safety Data Sheet (SDS). Contact the supplier for technical support or emergencies.

Also provide: