Audited Supplier
MC-RTV160
Synthetic Rubber
Silicone Rubber
Liquid
Liquid Rubber
RTV 160
a: Grey B: White
1:1
3600~3800 Cps
30~40 Mins
24 Hours
56~58 Shore a
20
3×1015
0.58
12 Months
MC SILICONE
20kg/Drum, 200kg/Drum
REACH, MSDS, SGS
Dongguan, China
39100000
Product Description
RTV 160 Grey Electrical Potting Silicone Compound for LED / Circuits Encapsulants
| Item No. | MCSIL-E160 |
| Color | gray |
| Mix Ratio | 1:1 |
| Viscosity mPa.s 25C | 3600~3800 |
| Density g/cm3 | 1.57±0.02 |
| Pot life min 25C | 30 |
| Curing time H | 24 |
| Curing time with heat min 100C | 10 |
| Hardness shore A | 56~58 |
| Dielectric strength kv/mm 25C | ≥20 |
| Volume resistivity DC500v Ω?cm | 3×10 15 |
| Tensile strength Mpa | ≥0.6 |
| Thermal conductivity w/m | 0.63 |
| Temperature C | -30-200 |
Silicone compound is supplied as a two-component addition cure system. It consists of Part A and Part B. The component A is grey and component B is white for easy identification and inspection of complete mixing.(colors can be adjusted as per customer requirement.)
When the components are thoroughly mixed in a 1:1 ratio by weight or volume, the liquid mixture cures to a flexible elastomer, which is suited for electrical/electronic potting and encapsulating applications.
Application
Silicone is a general purpose compound suited for adhesive and coating. This cost-effective silicone can be used in a variety of electronic potting applications including the adhesive and coating for solar power, HID, LCD displayer, circuit board and electronic components, etc.
Silicone is a general purpose compound suited for adhesive and coating. This cost-effective silicone can be used in a variety of electronic potting applications including the adhesive and coating for solar power, HID, LCD displayer, circuit board and electronic components, etc.
Using Instructions of Silicone Rubber For Electronic Encapsulating&Potting
1. Preparing: Clean up the coating surface, remove the rust, dust, oil dirt.
2. Pouring: Weigh the silicone and catalyst correctly, mix silicone part A and part B thoroughly, pour onto the electronic components/surface after vacuum degassing.
3. Curing: Room temperature cure or heat-up cure is both workable.
4. It should be use up after open the package, the material must be kept in a cool place sealed well, and it should avoid from contact with moisture in the air.
Note: Mechanical and electrical performance data tested at 25° C 7 days after curing, relative humidity of 55%; All the tested data is average value.
Packing and Storage
1. Silicone rubber is shipped as kits that Part A and B liquid components in separate containers. It is available in packing in 5kg or 20kg,200kg per pail.
2. Silicone rubber must be tightly sealed in cool and dry place, prevented from sun and rain. Transport by non-dangerous goods. It has a shelf life of 12 months.
