Audited Supplier
a Lifetime
1 Year
CE
New
Non-Customized
Automatic
Block Assembly
Hapro
Plywood
China
9024800000
Product Description
Laboratory Single screw Extruder can be integrated by main unit and single screw extrusion unit. That can be used to simulate real production process in the laboratory. Matched well with different die heads ,many functional simulation test in laboratory environment with Capillary Die,Pipe Die,Flat Die,Coating Wire Die and Other auxiliary equipments .The screw with different diameter, length-diameter radio and compress ratio can be chosen depending on the tested materials.
When paired with capillary molds, it can be used to test the viscosity of thermoplastic polymers
The correlation of material's viscosity and shearing speed and the relationship between its viscosity and shearing stress can be measured through Capillary Die. The principle of polymer's viscosity can be presented in the following way.
η =τ / γ
τ is shearing stress with the unit of kg/cm2 .
γ is shearing speed with the unit of 1/s.
τ and γ are acquired by pressure difference of tubule ends and extruding amount of fusant respectively.
Test the pressure difference of two ends of tubule and the extruding amount of fusant, through changing rotating speed of extruder screw from 5 to 100 rpm. Save all experiment data. And open the data file by software HPVisco. The data curves will be output on two coordinates with γ-η and γ-τ respectively..
When paired with capillary molds, it can be used to test the viscosity of thermoplastic polymers
The correlation of material's viscosity and shearing speed and the relationship between its viscosity and shearing stress can be measured through Capillary Die. The principle of polymer's viscosity can be presented in the following way.
η =τ / γ
τ is shearing stress with the unit of kg/cm2 .
γ is shearing speed with the unit of 1/s.
τ and γ are acquired by pressure difference of tubule ends and extruding amount of fusant respectively.
Test the pressure difference of two ends of tubule and the extruding amount of fusant, through changing rotating speed of extruder screw from 5 to 100 rpm. Save all experiment data. And open the data file by software HPVisco. The data curves will be output on two coordinates with γ-η and γ-τ respectively..
