Audited Supplier
Flexibond 8101T
Structural Adhesive
Solvent Free
Automobile, Construction, Boats, Bus, Truck
Polyurethane
Room Curing
Electrophoresis up to 230ºC
Grey
Poly Reaction
Grey
1.25 G/Cm^3
1.47 G/Cm^3
2:1
10-15 Min
168 H
up to 230ºC
3.5 MPa
2.5 MPa
450%
Flexibond
400ml 2: 1 Jointed Cartridge Set
ISO9001, ISO14001
China
3506100090
Product Description
DESCRIPTIONFlexibond 8101T is a two-component structural sealing MS polymer, which has excellent elongation, high bonding strength, and very good aging resistance under high temperature and humidity. 8101T is primer-less, has very good adhesion to various metal and non metal materials. It contains no volatile solvents, with non-sagging, moderate viscosity, fast curing and bonding effect. It also has good resistance for high temperature in short time, especially suits the needs for electronic coating processing.
ADVANTAGES
Flexibond 8101T can be used for various metal and non metal materials bonding such as iron, aluminum, galvanized sheet, glass, fiberglass, PC, MSC, ABS, PVC etc. It can resist with 180ºC backing, in short time up to 230ºC. If used with our primer, it also can be used bonding with PE, PP.
.
TECHNIACAL DATA SHEET
| Appearance | Grey | |
| Solid content (%) | 99.7% | |
| Modified Polymer | ||
| ComponentA | ComponentB | |
| Color | White uniform paste | Dark grey uniform paste |
| The color after mixing | Grey uniform paste | |
| Density (before curing) | 1.25g/cm3 | 1.47g/cm3 |
| Mixing ratio (by volume) | 100 | 50 |
| Mixing ratio (by mass) | 100 | 59 |
| Application time after mixing (25ºC, 50%RH) | 10-15mins | |
| Curing Condition (23ºC) | 168h | |
| Tensile strength (25ºC, 50%RH) | 3.5Mpa | |
| Shear strength | 2.5Mpa | |
| Elongation at break | 450% | |
APPLICATION
The substrates should be clean and dry and of no grease, dust, or other contaminations. The substrates can be cleaned by alcohol or acetone. Polish is recommended if with aluminum and other difficult adhesion materials.
- Put the cartridge into the manual or pneumatic applicator gun.
- Remove the stopper at the top the cartridge, and screw the extrusion-type nozzle, and then cut the nozzle into a suitable shape and size according to your need.
- Start the applicator gun and give up the sealant for the first 20cm, then apply to the substrates or the place for sealing.
- Substrates have been coated with adhesive should be pressed within application time, ensure the fully coating of substrate, or the adhesion strength will be affected. Two or more workers are recommended
- Replace with new nozzle If stop extrusion more than application time, make sure smooth processing
- After application, put back the stopper with the left sealants, screw tight, sealing well
- Must use with primer before application
CLEANING
Recommended Cleaner: Acetone, butanone.
PACKAGING
400ml 2:1 jointed cartridge set
200L metal drum
