Audited Supplier
FTDI's TTL-232RG-VIP to USB Serial Converter cable fitted with a TC2030 6-pin "No Legs" Tag-Connector.
Description:
This product is FTDI's TTL-232RG-VIP to USB Serial Converter cable fitted with a TC2030 "No Legs" Tag-Connector. This tiny footprint TC2030 debug connector requires no mating-half connector on the PCB saving target board cost and space.
Specification:
VCC: 1.8V to 5.25V
UART TTL level signals: VCC
Data rates: 3Mbps
Notes: VCC is a required Input, UART signal output levels match VCC and won't be present if VCC is not connected
Nominal cable length: 5.9ft/1.8m
| TC2030 pin | FTDI Signal | Type | Description |
|---|---|---|---|
| 1 | VCCIO (RED) | Input | VCC input. Power and voltage levels for the UART signals are supplied from the customers interface logic |
| 2 | CTS / TMS (BROWN) | Input | Clear to Send Control input / Handshake signal |
| 3 | RXD / TDI (YELLOW) | Input | Receive Asynchronous Data input |
| 4 | TXD / TCLK (ORANGE) | Output | Transmit Asynchronous Data output |
| 5 | GND (BLACK) | GND | Device ground supply pin |
| 6 | RTS / TDO (GREEN) | Output | Request To Send Control Output / Handshake signal |
TTL-232RG-VIP-WE Cable, TTL to USB Converter, Wire-End, 1.8m
Product Overview
The TTL-232RG-VIP-WE is an USB to UART cable with TTL voltage levels incorporating FT232RQ USB to serial UART interface IC which handles all the USB signalling and protocols. The cables provide a fast, simple way to connect devices with a logic level serial interface to USB. It contains a small internal electronic circuit board, utilising the FT232R, which is encapsulated into the USB connector end of the cable. The other end of the cable is wire ended. The cables can be used for TTL or interface logic over a range to voltage levels. The USB side of the cable is USB powered and is USB 2.0 full speed compatible. The cable is 1.8m long and supports a data transfer rate up to 3Mbaud. It supports the FTDIChip-ID, with a unique USB serial number programmed into the FT232R. This feature can be used to create a security or password protected file transfer access using the cable. This cables require USB drivers, which are used to make the FT232R in the cable appear as a virtual COM port.
- Any input voltage can be supplied by the customer from 1.8V (min value of VCCIO) to +5.25V
- USB 2.0 (12Mb/s) full speed compatible
- Connect directly to a microcontroller UART or I/O pins
- UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd/even/mark/space/no parity
- Internal EEPROM with user writeable area
- UHCI/OHCI/EHCI host controller compatible
- Voltage output power allows external logic to be powered from the USB port
- Entire USB protocol handled by the electronics in the cable USB
- Six way outputs provide Tx, Rx, RTS#, CTS#, VCC and GND
- Low USB bandwidth consumption
Applications
Communications & Networking, Sensing & Instrumentation, Industrial, Security, Automotive
