Audited Supplier
We design our thermostat hygrostat with a few must-have features that set them apart and make them the first choice for many different applications. Why are these features so important?
1. 2 Channel Options
Monitor and control the heater and fan at the same time separately. If cooling and heating applications exist simultaneously in an electrical enclosure, two traditional enclosure thermostats are installed while only one Blue Jay temperature and humidity controller is installed. That is, one temperature and humidity controller can replace two traditional enclosure thermostats.
2. Fan Control
Our temperature and humidity controller turns the fan on and off based on the humidity inside the cabinet, while the traditional electrical panel thermostat turns the fan on and off based on the temperature inside the cabinet.
3. Temperature Control
Our thermostat and hygrostat turn the heater on and off based on the temperature inside the cabinet, which is the same as the traditional enclosure thermostat. Read our guide to know working principle of thermostat.
4. Energy Efficient
Reduced energy consumption and optimization of the efficiency of the electronics inside the cabinet.
5. Adapted to any Environment
Blue Jay temperature and humidity thermostats are available in size and performance customization to fit within any environment, both indoor and outdoor. Contact us here and get the perfect electrical panel thermostat for your application.
| Power Supply | 85V~265VAC/DC 50Hz Optional 24/48DC |
| Power consumption | <5VA |
| Input signal channel | Max 2 channels |
| Temperature sensor | NTC (-20~99ºC) or customer request |
| Humidity sensor | Digital type (0~99%RH) or customer request |
| Sampling ratio | 400ms |
| Load control channel | Max 2 channels 250VAC, 5A (10A optional) |
| Analog Outputs (Optional) | 1 channel Isolated 0 / 4 … 20 mA |
| Alarms Outputs (Optional) | 1 channel DO 230 VAC 5 A |
| Communication Port (Optional) | RS485 (2/3 wires half duplex) Modbus RTU mode |
Available WSK Series Thermostat and Humidity Controller
| WSK--- | |
| Series Name | Optional Type |
| panel size | 72: For 72(W) x 72(H) x 96(D)mm |
| Blank: standard 48(W)x 48(H)x 90(D)mm | |
| temperature signal in | W1: one channel temperature sensor input |
| W2: two-channel temperature sensor input | |
| humidity signal in | S1: one channel humidity sensor input |
| S2: two-channel humidity sensor input | |
| control output | K1: one channel output relay |
| K2: two-channel output relay | |
| communication port | Blank:without this function |
| R: one channel RS-485 communication port | |
| sensor type | Blank: NTC sensor(0.2% accuracy) |
| T: thermocouple (-K, -],-T, -E, -N -R,-S, -B, -L, -U, -YXK) | |
| P: platinum RTD(-PT100- PT1000) | |
| L: linear signal(0~5V, 0~10V, 0~20mA, 4~20mA, 0~50mV) | |
