Audited Supplier
Aluminium Billet Melting & Casting Line
Product General Introduction
Meet the China national standard GB/T6892-2006 and Europe standard EN12020-1, (2001) and American Standard ANSI H35.2-2003.
We are a trustworthy supplier, constant business partner and sincere friend.We've dedicated in providing turn-key solutions for aluminium billet casting production line for 20 years, from 1 ton to 50 ton capacity of melting furnace. Furnace type includes vertical door furnace, inclined door furnace, fixed type furnace, dumping type furnace.
Our melting furnace is characterized by regenerative type and energy saving.
We have got ISO9001:2000 certification and the durability of our melting & casting line exceeds the similar products about 50% .Our excellent R&D staff guarantee that we can customize casting production line to customer requirements. And we are well known in this industry both home and abroad.
Product details
Regenerative Smelting furnace adopted flat topping and square structure. Aluminum ingot is the main input material. According to the requirement of technology, some solid matter (such as aluminum ingot head or tail) can be inputted appropriately.
Combustion system: regenerative combustion system that specialize in aluminum smelting furnace. Regenerative combustion system contains a pair of burner, and each one is connect with regenerative bed directly.
The working principle of combustion system: It is the best method of energy-saving for smelting furnace without any doubt. Burners combust circularly by turns. Waste gas is discharged by air exhauster through the regenerative bed of unburned burner after heat transferring. The average temperature of waste gas depends on the temperature of melting chamber, and it is in range of 150-300ºC. The switching between two burners is controlled by PLC system automatically.
Control system: consist of temperature detecting and controlling, burner automatic ignition, flame detecting and protection.
Ignition control: PLC detect whether the roof is over temperature; whether combustion-supporting air pressure and gas pressure are over the lower limit and other safety limit, upon which PLC decide to igniti or not. If all the conditions mentioned above are fulfilled, then the ignition gun starts to work.
2. Casting Machine
Dragging system: The dummy head can up and down vertical in the deep of casting well. Electrical machine is with frequency conversion design and speed is adjustable.
Lifting table: Four corner of lifting table is fixed with four guide equipment to make sure the vertical and parallelism between the lifting table and dummy head. The up and down of dummy head is realized with the driving help of winch to steel wire.The up and down of the casting machine is with the help of electrical machine, worm reducer and gear reducer.The casting length is decided by encoder signal.
Steel square tube,steel plate,winch,and four are all installed into the well frame.leaning base and leaning arm is installed on the well frame.Water-infowing connector is all installed beside leaning arm.
Winch system: the moving distance of the winch machine is more than 7 meter.which adjust speed with frequency converter,it can move up-and-down as well as inching or automatic.
Turnover machine: the design of the turnover machine of the casting machine is according to 80-90ºC,which can up and down cooridated with the casting machine. Electrical-controlling just can make sure the lift and tip-ove of casting machine realize single action.
Project Case
